| Procedure | Part Name Code |
|
|
|
|
| 1 | PRECAUTION | - | ( ) |
- | - |
| 2 | ENGINE SIDE COVER RH | 51473C | - | - | - |
| 3 | BATTERY STATE SENSOR ASSEMBLY | 28850C | - | - | - |
| *1 | BATTERY CURRENT SENSOR HOLDER | *2 | GROUND WIRE |
| *3 | ENGINE ROOM MAIN WIRE | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the battery state sensor assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
51473C 2.REMOVE ENGINE SIDE COVER RH
28850C 3.REMOVE BATTERY STATE SENSOR ASSEMBLY