Home › Suspension › SUSPENSION CONTROL › ELECTRONIC-KINETIC DYNAMIC SUSPENSION SYSTEM
RM38G0E _53 Suspension _100546 SUSPENSION CONTROL _0470891 ELECTRONIC-KINETIC DYNAMIC SUSPENSION SYSTEM Y

SUSPENSION CONTROL  ELECTRONIC-KINETIC DYNAMIC SUSPENSION SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
Result:
Proceed to
NEXT



NEXT

3.INSPECT BATTERY VOLTAGE
3.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

4.CHECK DTC, FREEZE FRAME DATA AND VEHICLE CONTROL HISTORY (RoB)
4.CHECK DTC, FREEZE FRAME DATA AND VEHICLE CONTROL HISTORY (RoB)
a.

Check DTCs and freeze frame data.

i.

Check and record DTCs.

Chassis > Electronic-Kinetic Dynamic Suspension System (E-KDSS) > Trouble Codes
50001 5002

ii.

Check and record freeze frame data.



b.

Clear the DTCs and freeze frame data.

Chassis > Electronic-Kinetic Dynamic Suspension System (E-KDSS) > Clear DTCs
50002 5002

c.

Recheck for DTCs.

Chassis > Electronic-Kinetic Dynamic Suspension System (E-KDSS) > Trouble Codes
50001 5002
i.

Reproduce the problem symptoms based on the recorded DTCs and freeze frame data, and then check if the DTCs are output again.

HINT:
·

When DTCs indicating a CAN communication system malfunction are output, first troubleshoot and repair the CAN communication system.

·

If the GTS cannot communicate with the stabilizer control ECU, check CAN communication between the DLC3 and the stabilizer control ECU, and also check the IG circuit of the stabilizer control ECU.






Result:
Result Proceed to
DTC is not output but problem symptoms can be reproduced and confirmed A
DTC is output B
DTC is not output and problem symptoms cannot be reproduced and confirmed C
DTC is not output and vehicle control history is output D



A

5.PROBLEM SYMPTOM CONFIRMATION

B

REFER TO DIAGNOSTIC TROUBLE CODE CHART, PERFORM TROUBLESHOOTING ACCORDING TO PROCEDURE FOR EACH DTC AND GO TO STEP 7

C

D

PERFORM TROUBLESHOOTING AND REPAIRS RELATED TO VEHICLE CONTROL HISTORY

Click hereSuspension>SUSPENSION CONTROL>ELECTRONIC-KINETIC DYNAMIC SUSPENSION SYSTEM>VEHICLE CONTROL HISTORY (RoB)

NOTICE:

After performing troubleshooting and repairs related to the vehicle control history, clear the vehicle control history.



5.PROBLEM SYMPTOM CONFIRMATION
Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table. A
Fault is listed in Problem Symptoms Table. B



A

6.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

PERFORM TROUBLESHOOTING ACCORDING TO PROCEDURE FOR EACH CORRESPONDING SYMPTOM AND GO TO STEP 8

6.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

7.REPAIR OR REPLACE
7.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

8.CONFIRMATION TEST
8.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END