| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | PRECAUTION | - | ( ) |
- | - |
| 2 | QUARTER TRIM PANEL ASSEMBLY RH | 62510M | - | - | - |
| 3 | DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL | - | - | - | - |
| 4 | STABILIZER CONTROL ECU | 89271A | ( ) |
- | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the stabilizer control ECU removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
62510M 2.REMOVE QUARTER TRIM PANEL ASSEMBLY RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>SEAT BELT>REAR NO. 2 SEAT OUTER BELT ASSEMBLY>REMOVAL
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
89271A 4.REMOVE STABILIZER CONTROL ECU
|
|