|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
52380D 1.TEMPORARILY TIGHTEN FRONT DIFFERENTIAL SUPPORT ASSEMBLY
41110F 2.INSTALL FRONT DIFFERENTIAL CARRIER ASSEMBLY
Support the front differential with a jack.
| *a | Paint Mark A | *b | Paint Mark B |
| *c | Clip Positioning Area (72.5°) | - | - |
Connect the differential breather tube to the front differential carrier assembly.
Align the paint mark A on the differential breather tube and breather pipe.
Install the clip to the breather pipe.
Align the clip at the locations shown in the illustration and install them.
|
Install in this Direction | - | - |
Install the front differential carrier assembly shown in the illustlation.
Install the 2 bolts and 2 nuts.
52380E 3.INSTALL DIFFERENTIAL SUPPORT ASSEMBLY
52380D 4.FULLY TIGHTEN FRONT DIFFERENTIAL SUPPORT ASSEMBLY
|
|
37140 5.INSTALL FRONT PROPELLER SHAFT ASSEMBLY
43420 6.INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
43410 7.INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
Use the same procedure described for the LH side.