| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT DRIVE SHAFT HOLE SNAP RING | 43420G | ( ) |
- | - |
| 2 | FRONT DRIVE SHAFT ASSEMBLY LH | 43420 | ( ) |
- | - |
| 3 | DIFFERENTIAL OIL | - | - | - | - |
| 4 | STEERING KNUCKLE | - | - | - | - |
|
MP Grease |
|
Differential oil |
|
Do not apply lubricants to the threaded parts | ● | Non-reusable part |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 5 | NO. 2 ENGINE UNDER COVER ASSEMBLY | 51420 | - | - | - |
| 6 | NO. 1 ENGINE UNDER COVER ASSEMBLY | 51410 | - | - | - |
| *A | for V35A-FTS, w/ Cover | *B | for V35A-FTS, w/o Cover |
| *C | for 1GR-FE | - | - |
| *1 | ENGINE SIDE COVER SUB-ASSEMBLY LH | *2 | ENGINE SIDE COVER SUB-ASSEMBLY RH |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
43420G 1.INSTALL FRONT DRIVE SHAFT HOLE SNAP RING
Install a new front drive shaft hole snap ring.
Do not damage the spline of the inboard joint.
The front drive shaft hole snap ring should be installed completely.
43420 2.INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
Coat the splines of the inboard joint with differential oil.
Coat the snap ring of the inboard joint with MP grease.
Align the splines and tap in the front drive shaft assembly LH with a brass bar and hammer.
Using MP grease, set the front drive shaft hole snap ring in the groove with the opening facing downwards and centered radially.
Do not damage the inboard joint boot, front drive shaft dust cover LH and differential side gear shaft oil seal.
Make sure to follow the proper handling and installation procedures. If the front drive shaft assembly LH is installed at too large an angle or slides too much, it may fall out of the groove of the tripod joint.
Do not tap the end of the front drive outboard joint assembly with a hammer, etc.
Determine whether the front drive shaft assembly LH is completely tapped in by checking for changes in the tapping sound or the reaction of the brass bar.
4.INSTALL STEERING KNUCKLE
51420 5.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
for V35A-FTS: Click hereEngine / Hybrid System>V35A-FTS (ENGINE MECHANICAL)>ENGINE ASSEMBLY>INSTALLATION
for 1GR-FE: Click hereEngine / Hybrid System>1GR-FE (ENGINE MECHANICAL)>ENGINE ASSEMBLY>INSTALLATION
51410 6.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
for V35A-FTS: Click hereEngine / Hybrid System>V35A-FTS (LUBRICATION)>OIL PAN AND OIL LEVEL SENSOR>INSTALLATION
for 1GR-FE: Click hereEngine / Hybrid System>1GR-FE (LUBRICATION)>OIL LEVEL SENSOR>INSTALLATION