The No. 4 air conditioning radiator damper servo sub-assembly sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on these signals to move the air mix damper to the appropriate position. This adjusts the amount of air passing through the heater core after passing the evaporator and controls the temperature of the output air. The air conditioning amplifier assembly communicates with the servo through a communication/driver IC and wiring assembly called the air conditioning harness assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from | Priority |
|---|---|---|---|---|---|---|
| B14E27F | Front Control Rear Right Air Mix Damper Control Servo Motor Actuator Stuck Off | Diagnosis Condition: No. 4 air conditioning radiator damper servo sub-assembly operation Malfunction Status: The damper servo operation request signal is output but the position information of the servo does not change or servo is malfunctioning Detection Time: Continuously for 30 seconds or more |
·
No. 4 air conditioning radiator damper servo sub-assembly
·
Air conditioning harness assembly
·
Air conditioning radiator assembly
·
Air conditioning amplifier assembly |
Memorized | Air Conditioner | A |
| Vehicle Condition | |||
|---|---|---|---|
| Pattern 1 | Pattern 2 | ||
| Diagnosis Condition | No. 4 air conditioning radiator damper servo sub-assembly operating | ○ | ○ |
| Malfunction Status | Damper servo operation request signals are output but the damper position sensor value does not change | ○ | - |
| Damper servo operation request signals are output but the damper position sensor value is abnormal | - | ○ | |
| Detection Time | Continuously for 30 seconds or more | Continuously for 30 seconds or more | |
| Trip Count | 1 trip | 1 trip | |
If the conditions of either of these patterns are detected, a DTC will be stored.
Check for DTCs.
| Result | Proceed to |
|---|---|
| B14E27F is output | A |
| DTCs in conjunction with No. 4 air conditioning radiator damper servo sub-assembly are output at same time | B |
A
B
Check that the No. 4 air conditioning radiator damper servo sub-assembly is installed correctly.
The No. 4 air conditioning radiator damper servo sub-assembly is installed correctly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check for a wire harness caught between the links of the motors and dampers.
No wire harnesses are caught between the links of the motors and dampers.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Using the GTS, perform the following Active Test and read the Data List value.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Fr Control RR Air Mix Damper Control Servo Motor | No. 4 air conditioning radiator damper servo sub-assembly operation | Min: 128 Max: 384 |
Operates between 154 to 258 |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Front Control Rear Right Air Mix Damper Control Servo Motor Actual Pulse | No. 4 air conditioning radiator damper servo sub-assembly actual pulse | 128 to 384 |
·
MAX COLD: 258 (pulse)
·
MAX HOT: 154 (pulse) |
- |
| Active Test Display |
|---|
| Fr Control RR Air Mix Damper Control Servo Motor |
| Data List Display |
|---|
| Front Control Rear Right Air Mix Damper Control Servo Motor Actual Pulse |
The value of the Data List changes in accordance with the operation of the Active Test.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Using the GTS, perform the following Active Test and read the Data List value.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Fr Control RR Air Mix Damper Control Servo Motor | No. 4 air conditioning radiator damper servo sub-assembly operation | Min: 128 Max: 384 |
Operates between 154 to 258 |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Front Control Rear Right Air Mix Damper Control Servo Motor Target Pulse | No. 4 air conditioning radiator damper servo sub-assembly target pulse | 128 to 384 |
·
MAX COLD: 258 (pulse)
·
MAX HOT: 154 (pulse) |
- |
| Front Control Rear Right Air Mix Damper Control Servo Motor Actual Pulse | No. 4 air conditioning radiator damper servo sub-assembly actual pulse | 128 to 384 |
·
MAX COLD: 258 (pulse)
·
MAX HOT: 154 (pulse) |
- |
| Active Test Display |
|---|
| Fr Control RR Air Mix Damper Control Servo Motor |
| Data List Display |
|---|
| Front Control Rear Right Air Mix Damper Control Servo Motor Target Pulse |
| Front Control Rear Right Air Mix Damper Control Servo Motor Actual Pulse |
The target pulse value of the Data List matches the actual pulse.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, perform the following Active Test and read the Data List value.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Fr Control RR Air Mix Damper Control Servo Motor | No. 4 air conditioning radiator damper servo sub-assembly operation | Min: 128 Max: 384 |
Operates between 154 to 258 |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Front Control Rear Right Air Mix Damper Control Servo Motor Actual Pulse | No. 4 air conditioning radiator damper servo sub-assembly actual pulse | 128 to 384 |
·
MAX COLD: 258 (pulse)
·
MAX HOT: 154 (pulse) |
- |
| Active Test Display |
|---|
| Fr Control RR Air Mix Damper Control Servo Motor |
| Data List Display |
|---|
| Front Control Rear Right Air Mix Damper Control Servo Motor Actual Pulse |
The value of the Data List changes in accordance with the operation of the Active Test.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Using the GTS, perform the following Active Test and read the Data List value.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Front Right Air Mix Damper Control Servo Motor | No. 4 air conditioning radiator damper servo sub-assembly operation | Min: 128 Max: 384 |
Operates between 186 to 258 |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Front Right Air Mix Damper Control Servo Motor Actual Pulse | No. 4 air conditioning radiator damper servo sub-assembly actual pulse | 128 to 384 |
·
MAX COLD: 258 (pulse)
·
MAX HOT: 186 (pulse) |
- |
| Active Test Display |
|---|
| Front Right Air Mix Damper Control Servo Motor |
| Data List Display |
|---|
| Front Right Air Mix Damper Control Servo Motor Actual Pulse |
The value of the Data List changes in accordance with the operation of the Active Test.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Pre-procedure1
Remove the No. 4 air conditioning radiator damper servo sub-assembly.
for LHD:Vehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT (for LHD)>DISASSEMBLY
for RHD:Vehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT (for RHD)>DISASSEMBLY
Procedure1
Operate the dampers by hand.
The dampers are easily operated by hand.
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG