| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | TCM | 89530C | ( ) |
- | - |
| *1 | TRANSFER BREATHER HOSE SUB-ASSEMBLY | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
| *A | for V35A-FTS | *B | for F33A-FTV |
| *C | w/ Cover | *D | w/o Cover |
| *1 | ENGINE SIDE COVER SUB-ASSEMBLY LH | *2 | ENGINE SIDE COVER SUB-ASSEMBLY RH |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
After replacing the TCM, make sure to perform ECU configuration.
After performing the ECU configuration procedure and update ECU security key procedure, make sure to perform the initialization procedure for when the cable has been disconnected and reconnected to the negative (-) auxiliary battery terminal.
89530C 1.INSTALL TCM
|
Securely Lock | - | - |
Install the TCM to the automatic transmission assembly with the 4 bolts.
Connect the TCM connector and rotate the lever and attach the claw.
Securely lock the TCM connector lever.
Attach the clamp and connect the transfer breather hose sub-assembly to the automatic transmission assembly.
2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
3.INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
4. ECU CONFIGURATION
|
|
5. UPDATE ECU SECURITY KEY
51450C 6.INSTALL FRAME UNDER COVER ASSEMBLY LH (w/ Cover)
51430A 7.INSTALL FRAME UNDER COVER ASSEMBLY RH
51420 8.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
51410 9.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
10.PERFORM REGISTRATION
11.PERFORM INITIALIZATION