Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Manual Seat) › from 2021.07
RM38G0E _58 Vehicle Interior _100628 SEAT _0468250 FRONT SEAT ASSEMBLY(for Manual Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Manual Seat)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B610931N01
2.448,0.323 3.198,0.323 3.198,0.323 3.604,0.927 false 6.583,0.167 6.75,0.167 false 6.583,0.5 6.75,0.5 false 3.75,0.417 4.5,0.417 false 4.292,1.833 4.292,1.333 4.292,1.333 4.458,1.333 false 4.667,2.083 4.667,1.667 4.667,1.667 5,1.667 false 2.219,2.031 2.469,2.031 2.469,2.031 2.469,2.344 false 2.167,2.531 2.448,2.531 2.448,2.531 2.833,2.583 false 6.406,0.031 6.688,0.385 0.281,0.354 18 false 1 6.125,0.333 6.406,0.688 0.281,0.354 18 false 2 1.99,2.385 2.271,2.74 0.281,0.354 18 false 4 2.031,1.906 2.313,2.26 0.281,0.354 18 false 5 5,1.531 5.281,1.885 0.281,0.354 18 false 6 4.469,1.198 4.75,1.552 0.281,0.354 18 false 7 2.26,0.188 2.542,0.542 0.281,0.354 18 false 8 4.51,0.271 4.792,0.625 0.281,0.354 18 false 3 2.979,0.625 3.438,0.823 0.458,0.198 10 false x 4 6.292,0.396 6.646,0.625 0.354,0.229 12 false (*A)

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL - (Click here) - -
3 FRONT SEAT HEADREST ASSEMBLY LH 71910F - - -
4 FRONT OUTER SEAT TRACK BRACKET COVER LH 72123M (Click here) - -
5 FRONT INNER SEAT TRACK BRACKET COVER LH 72123L (Click here) - -
6 REAR OUTER SEAT TRACK BRACKET COVER LH 72137Y - - -
7 REAR INNER SEAT TRACK BRACKET COVER LH 72158F - - -
8 FRONT SEAT ASSEMBLY LH - (Click here) - -

*A w/ Front Seat Side Airbag - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seat assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

CAUTION:
B543257

·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



NOTICE:
·

If the front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback spring sub-assembly, front seatback pad and front seatback cover sub-assembly with the necessary parts in accordance with the extent of the collision damage.

·

Replace any other damaged parts as necessary.



HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering ilghts Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read precautionary notices concerning the SRS airbag system before servicing.

(Click here)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

Z101186

CAUTION:
B422343

·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.







Hide 71910F 3.REMOVE FRONT SEAT HEADREST ASSEMBLY LH

a.
B609715


Hide 72123M 4.REMOVE FRONT OUTER SEAT TRACK BRACKET COVER LH

a.
B609716C01
0.208,0.167 0.49,0.521 0.281,0.354 18 false i 1.938,2.167 2.219,2.521 0.281,0.354 18 true ii 4.01,2.583 4.292,2.938 0.281,0.354 18 true iii 5.323,3.156 5.604,3.51 0.281,0.354 18 true iii
V113146

Place Hands Here
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2) - -


i.

Operate the seat track adjusting handle LH and move the front seat assembly LH to the rearmost position.


ii.

Using a thin-bladed screwdriver, detach the claw.

HINT:

Tape the thin-bladed screwdriver tip before use.



iii.

Place your hands at the position shown in the illustration and slide in the removal direction (2) while pulling in the removal direction (1) to detach the guide and remove the front outer seat track bracket cover LH.



Hide 72123L 5.REMOVE FRONT INNER SEAT TRACK BRACKET COVER LH

a.

Use the same procedure described for the front outer seat track bracket cover LH.


Hide 72137Y 6.REMOVE REAR OUTER SEAT TRACK BRACKET COVER LH

a.
B609717C01
3.448,2.844 4.948,2.781 true 5.01,2.688 5.323,2.885 0.313,0.198 10 false *a
*a Protective Tape - -
V113147

Remove in this Direction - -



Hide 72158F 7.REMOVE REAR INNER SEAT TRACK BRACKET COVER LH

a.

Use the same procedure described for the rear outer seat track bracket cover LH.


Hide 8.REMOVE FRONT SEAT ASSEMBLY LH

a.
B609718C01
2.469,1.438 2.667,1.74 0.198,0.302 18 true i 0.833,1.427 1.031,1.729 0.198,0.302 18 true i 3.823,1.427 4.042,1.719 0.219,0.292 18 true iii 3.323,0.052 3.542,0.354 0.219,0.302 18 true iii 5.104,1.031 5.323,1.344 0.219,0.313 18 true iv 6.677,1.125 6.885,1.427 0.208,0.302 18 true v 2.958,0.885 3.135,1.177 0.177,0.292 18 true ii 5.823,0.25 6.094,0.552 0.271,0.302 18 true vi 6.104,0.333 6.479,0.573 0.375,0.24 12 true (*A)
*A for Driver Side - -


i.

Using a T50 "TORX" socket wrench, remove the 2 "TORX" screws.


ii.

Operate the seat track adjusting handle LH and move the front seat assembly LH to the rearmost position.


iii.

Using a T50 "TORX" socket wrench, remove the 2 "TORX" screws.


iv.

Operate the seat track adjusting handle LH and move the front seat assembly LH to the center position.


v.

Operate the reclining adjuster release handle LH to set the seatback of the front seat assembly LH to the perpendicular position.


vi.

for Driver Side:

1. Operate the front seat vertical adjuster handle LH to set the seat cushion height to the highest position.



b.
B610950C03
3.802,1.25 3.948,1.542 0.146,0.292 18 true i 3.969,1.323 4.302,1.563 0.333,0.24 12 true (*A) 3.042,0.708 3.24,1.01 0.198,0.302 18 true ii
*A w/ Front Seat Side Airbag - -


i.

w/ Front Seat Side Airbag:

1. Disconnect the connector of the front seat airbag assembly LH.

NOTICE:

Do not pull while holding the wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



ii.

Disconnect the connector and detach the clamp under the front seat assembly LH to remove the floor wire harness.



c.
B609719C01
0.448,0.052 0.729,0.406 0.281,0.354 18 false i

i.

Remove and carry the front seat assembly LH out of the vehicle.

NOTICE:
·

Protect the front seat legs.

·

Carrying the front seat assembly LH from the vehicle must be performed by multiple people.

·

Do not damage the front seat assembly LH, body exterior or interior parts.