| *A | w/ Curtain Shield Airbag | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front seat outer belt assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
Move both front seats to the frontmost position and fold them forward.
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
|
|
for 1GR-FE:
for V35A-FTS:
for F33A-FTV:
67914B 3.REMOVE FRONT DOOR SCUFF PLATE LH
67918D 4.REMOVE REAR DOOR SCUFF PLATE LH
74617C 6.REMOVE ASSIST GRIP PLUG (for Upper Side)
Use the same procedure described for the Lower side.
74620A 7.REMOVE REAR ASSIST GRIP ASSEMBLY
73233 8.REMOVE OUTER LAP BELT ANCHOR COVER
73220 9.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR)
62414A 10.REMOVE CENTER PILLAR LOWER GARNISH LH
62412 11.REMOVE CENTER PILLAR GARNISH LH
73024 12.REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH
Perform this procedure when replacing the front shoulder belt anchor plate sub-assembly LH.
73220 13.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH
| *A | w/ Tension Reducer | - | - |
|
Nut |
|
Pretensioner Connector |
|
Tension Reducer Connector |
|
Bolt |
Remove the nut and shoulder anchor of the front seat outer belt assembly LH.
Disconnect the pretensioner connector.
Refer to How to Connect or Disconnect Airbag Connector:
w/ Tension Reducer:
1. Disconnect the tension reducer connector.
Remove the bolt.
Detach the guide and remove the front seat outer belt assembly LH.
73200A 14.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Perform this procedure when replacing the front shoulder belt anchor adjuster assembly.