| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | REAR NO. 1 SEAT ASSEMBLY RH | - | - | - | - |
| *A | w/ Child Restraint System Guide | *B | w/o Wire Harness |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear center seat 3 point type belt assembly removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Move both front seats to the frontmost position and fold them forward.
1.REMOVE REAR NO. 1 SEAT ASSEMBLY RH
72329F 3.REMOVE REAR SEAT ADJUSTER BOLT COVER
72525R 4.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH
78950F 6.REMOVE NO. 1 FOLD SEAT STOPPER BAND ASSEMBLY
79952A 7.REMOVE NO. 1 SEAT NO. 2 CUSHION COVER
79951B 8.REMOVE NO. 1 SEAT NO. 1 CUSHION COVER
79967W 9.REMOVE REAR NO. 1 SEAT NO. 4 LEG SIDE COVER
82193 10.REMOVE REAR SEAT WIRE RH (w/o Wire Harness)
71302C 11.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH
71301G 12.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH
72995F 13.REMOVE REAR SEAT CUSHION COVER RH
72927F 14.REMOVE REAR SEAT CUSHION UNDER COVER RH
73380C 15.REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY RH
73310D 16.DISCONNECT REAR CENTER SEAT 3 POINT TYPE BELT ASSEMBLY (SEAT ANCHOR)
72996H 17.REMOVE REAR SEATBACK COVER (w/ Child Restraint System Guide)
72996J 18.REMOVE REAR NO. 2 SEATBACK COVER (w/ Child Restraint System Guide)
71701A 19.REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY RH
73178A 20.REMOVE SEAT BELT ANCHOR COVER CAP
73373 21.REMOVE REAR SEAT SHOULDER BELT COVER
71930Q 22.REMOVE REAR SEAT HEADREST SUPPORT ASSEMBLY
23.REMOVE SEPARATE TYPE REAR SEATBACK ASSEMBLY RH
73310D 24.REMOVE REAR CENTER SEAT 3 POINT TYPE BELT ASSEMBLY
|
Remove in this Direction | - | - |