Home › Engine / Hybrid System › F33A-FTV (ENGINE CONTROL) › ECD SYSTEM (w/ DPF) › from 2021.07
RM38G0E _51 Engine / Hybrid System _106329 F33A-FTV ENGINE CONTROL _0484871 ECD SYSTEM(w/ DPF) C

F33A-FTV ENGINE CONTROL  ECD SYSTEM(w/ DPF)  P20CB00  Exhaust Aftertreatment Fuel Injector "A" Control Performance  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note
P20CB00 Exhaust Aftertreatment Fuel Injector "A" Control Performance When the exhaust fuel addition F/B bank 1 learned 3 times at the upper limit during PM forced regeneration
(1 trip detection logic)
Exhaust Fuel Addition Injector Assembly Does not come on SAE Code: P20CC

Related Data List
DTC No. Data List
P20CB00 Exhaust Fuel Addition F/B Bank 1

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P20CB00 PM forced regeneration

PROCEDURE

1.REPLACE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

Click hereEngine / Hybrid System>F33A-FTV (EMISSION CONTROL)>EXHAUST FUEL ADDITION INJECTOR>REMOVAL

HINT:

Clean any deposits from the fuel addition area inside the exhaust pipe when replacing the exhaust fuel addition injector assembly.


Result:
Proceed to
NEXT



NEXT

2.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
2.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 372

b.

Turn the ignition switch off and wait for 30 seconds or more.


c.

Start the engine and warm it up until the engine coolant temperature reaches 75°C (167°F) or higher.



e.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 372

f.

Confirm that the DTC is not output.


Result:
Proceed to
NEXT



NEXT

END