| *1 | Engine wire | *2 | Exhaust pipe clamp sub-assembly |
| ● | Non-reusable part | - | - |
1.DRAIN ENGINE COOLANT (for Intercooler)
12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
17951 3.REMOVE INTERCOOLER INSULATOR
|
|
23901H 4.DISCONNECT FUEL TUBE SUB-ASSEMBLY
|
|
Disconnect the fuel tube sub-assembly.
Click hereEngine / Hybrid System>F33A-FTV (FUEL)>FUEL SYSTEM>PRECAUTION
1629GA 5.DISCONNECT NO. 20 WATER BY-PASS HOSE
|
|
1629H 6.DISCONNECT NO. 21 WATER BY-PASS HOSE
|
|
23600G 7.REMOVE EXHAUST FUEL ADDITION INJECTOR HEAT INSULATOR
|
|
23710B 8.REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY
|
|
Disconnect the connector.
Detach the 2 clamps.
Remove the exhaust pipe clamp sub-assembly.
Remove the exhaust fuel addition injector assembly from the exhaust manifold converter sub-assembly.
25051 9.CLEAN EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
| *a | The hole is not clogged. No cleaning required. | *b | The hole is clogged. Cleaning required |
Visually check the carbon deposits on the exhaust fuel addition injector hole.
| *a | OK | *b | Carbon deposits remain. Cleaning incomplete. |
Using a wire brush, clean the exhaust fuel addition injector hole until the entire circumference of the metal surface is visible.
Wear safety goggles when cleaning with an air duster.
If carbon deposits enter your eyes, immediately wash your eyes thoroughly with tap water and promptly consult a physician.
Deposits that enter into the exhaust manifold converter while cleaning will be removed by incineration from the exhaust heat.
Using solvent, wipe the addition injector installation area.