Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING SUPPORT BRAKE SYSTEM › from 2021.07
RM38G0E _56 Audio / Visual / Telematics _100728 PARK ASSIST / MONITORING _0469671 PARKING SUPPORT BRAKE SYSTEM U

PARK ASSIST / MONITORING  PARKING SUPPORT BRAKE SYSTEM  TERMINALS OF ECU  


CLEARANCE WARNING ECU ASSEMBLY


E220917N88
3.375,0.219 3.74,0.458 0.365,0.24 3.458,0.24 3.792,0.427 0.333,0.188 10 false I58

a.

Disconnect the I58 clearance warning ECU assembly connector.


b.

Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.

Terminal No. (Symbol) Terminal Description Condition Specified Condition

*1: w/o Stop and Start System

*2: w/ Stop and Start System

I58-1 (IG) - I58-31 (E) IG power source signal Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V*1
10.5 to 16 V*2
I58-12 (CLSW) - Body ground Parking support brake system main switch
·

Ignition switch ON

·

Parking support brake system main switch off


Below 1 V
·

Ignition switch ON

·

Parking support brake system main switch on


11 to 14 V
I58-31 (E) - Body ground Ground Always Below 1 Ω


c.

Reconnect the I58 clearance warning ECU assembly connector.


d.

Measure the voltage, resistance and check for pulses according to the value(s) in the table below.

Terminal No. (Symbol) Terminal Description Condition Specified Condition
I58-2 (BOF) - I58-31 (E) Power source for front sensor circuit
·

Ignition switch ON

·

Parking support brake system on


11 to 14 V
I58-3 (E5) - I58-31 (E) Ground for front clearance sonar Always Below 1 Ω
I58-4 (SOF) - I58-31 (E) Front sensor communication signal (Front clearance sonar sensor)
·

Ignition switch ON

·

Parking support brake system on

·

Shift position in any position other than P

·

Vehicle speed is less than approximately 10 km/h (6 mph)


Pulse generation
(Refer to waveform 1)
I58-9 (CBZ) - I58-8 (EF) No. 1 clearance warning buzzer signal Buzzer sounding Pulse generation
(Refer to waveform 2)
I58-26 (BBZ) - I58-25 (ER) No. 2 clearance warning buzzer signal Buzzer sounding Pulse generation
(Refer to waveform 2)
I58-19 (BOR) - I58-31 (E) Power source for rear sensor circuit
·

Ignition switch ON

·

Parking support brake system on


11 to 14 V
I58-20 (E1) - I58-31 (E) Ground for rear clearance sonar Always Below 1 Ω
I58-21 (SOR) - I58-31 (E) Rear sensor communication signal (Rear clearance sonar sensor)
·

Ignition switch ON

·

Parking support brake system on

·

Shift position in R


Pulse generation
(Refer to waveform 3)


e.

Using an oscilloscope, check waveform 1.

i.
E456275N01
0.167,1.229 0.625,1.427 0.458,0.198 10 false GND

Waveform 1 (Reference)

Item Content
Measurement terminal I58-4 (SOF) - I58-31 (E)
Measurement setting 5 V/DIV., 100 μs./DIV.
Condition
·

Ignition switch ON

·

Parking support brake system on

·

Shift position in any position other than P

·

Vehicle speed less than approximately 10 km/h (6 mph)





f.

Using an oscilloscope, check waveform 2.

i.
E227014N05
0.083,1.677 0.552,1.938 0.469,0.26 10 GND

Waveform 2 (Reference)

Item Content
Measurement terminal I58-9 (CBZ) - I58-8 (EF)
I58-26 (BBZ) - I58-25 (ER)
Measurement setting 2 V/DIV., 500 μs./DIV.
Condition Buzzer sounding

HINT:

The amplitude of the waveform changes according to the set volume.




g.

Using an oscilloscope, check waveform 3.

i.
E456275N01
0.167,1.229 0.625,1.427 0.458,0.198 10 false GND

Waveform 3 (Reference)

Item Content
Measurement terminal I58-21 (SOR) - I58-31 (E)
Measurement setting 5 V/DIV., 100 μs./DIV.
Condition
·

Ignition switch ON

·

Parking support brake system on

·

Shift position in R








BLIND SPOT MONITOR SENSOR (w/ Rear Crossing Vehicles Function)


Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>TERMINALS OF ECU


REAR TELEVISION CAMERA ASSEMBLY (w/ Rear Pedestrians Function)


Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>TERMINALS OF ECU