| *1 | HOOD TO COWL TOP SEAL | *2 | ENGINE ROOM MAIN WIRE |
The necessary procedures(adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the glow plug controller removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
51474B 3.REMOVE ENGINE SIDE COVER LH
55782D 4.DISCONNECT COWL TOP VENTILATOR LOUVER LH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
28551 5.REMOVE GLOW PLUG CONTROLLER
28559 6.REMOVE NO. 1 GLOW PLUG CONTROLLER BRACKET
28559A 7.REMOVE NO. 2 GLOW PLUG CONTROLLER BRACKET