| *A | BANK 2 | - | - |
| *1 | ENGINE OIL LEVEL DIPSTICK | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
|
Engine oil | - | - |
| *A | BANK 2 | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
19850 1.INSTALL GLOW PLUG ASSEMBLY
|
|
Clean the glow plug hole.
Wrap tape around a drill bit with a diameter of 4.8 mm (0.189 in.), 111.9 mm (4.41 in.) from its tip.
Insert the drill bit 111.9 mm (4.41 in.) into the glow plug hole (up to the tape) and remove any carbon deposits by turning the drill bit by hand.
Insert a drill bit with a diameter of 3.9 mm (0.154 in.) into the glow plug hole and remove any carbon deposits from the end of the glow plug hole by turning the drill bit by hand.
Using a 10 mm deep socket wrench, install the 6 glow plug assemblies.
19872 2.INSTALL NO.2 GLOW PLUG CONNECTOR
19871 3.INSTALL NO.1 GLOW PLUG CONNECTOR
19850B 4.INSTALL GLOW PLUG SCREW GROMMET
12142 5.INSTALL NO.2 ENGINE OIL LEVEL DIPSTICK GUIDE
| *a | Apply a light coat of engine oil | - | - |
17853B 6.INSTALL INTAKE MANIFOLD INSULATOR
28101 7.INSTALL STARTER HOSE BRACKET SUB-ASSEMBLY
53785B 8.INSTALL FRONT FENDER APRON TRIM PACKING D
53784 9.INSTALL FRONT FENDER APRON TRIM PACKING C
10.CONNECT BATTERY NEGATIVE TERMINAL
11. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART