Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Start Function) › from 2021.07
RM38G0E _58 Vehicle Interior _100610 THEFT DETERRENT / KEYLESS ENTRY _0467507 ENTRY AND START SYSTEM(for Start Function) C

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM(for Start Function)  B277B57  Fingerprint Code for Engine/Power Switch Invalid/Incompatible Software Component  


DESCRIPTION

This DTC is output when there is a code calculation mismatch between the certification ECU (smart key ECU assembly) and engine switch, if the engine switch was replaced with a new one but the technician forgot to perform registration between ECUs, or if the engine switch was replaced with a used one.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
B277B57 Fingerprint Code for Engine/Power Switch Invalid/Incompatible Software Component There is at least 1 electrical key transmitter sub-assembly (electrical key) already registered and any of the following conditions is met 10 times continuously
·

F code certification does not match

·

Unknown signal received from fingerprint authentication engine switch


Engine switch Entry&Start A DTC output confirmation operation:

Any of the conditions below is met


·

Fingerprint authentication is active and an engine start operation is performed

·

Fingerprint information is added or cleared



CAUTION / NOTICE / HINT

NOTICE:
·

When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

·

Check if the engine can be started before performing troubleshooting.

·

The entry and start system (for Start Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the entry and start system (for Start Function) after confirming that the communication systems are functioning properly.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Start Function)>HOW TO PROCEED WITH TROUBLESHOOTING

·

Before replacing the engine switch, refer to Service Bulletin.

·

After performing repairs, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".



PROCEDURE

1.REGISTER COMMUNICATION ID (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - ENGINE SWITCH)
a.

Register the ECU code registration.

HINT:

Refer to Service Bulletin.


Result:
Proceed to
NEXT




NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Using the GTS, check for DTCs.

Body Electrical > Entry&Start > Trouble Codes
50001 440

Result:
Result Proceed to
B277B57 is output A
B277B57 is not output B



A

3.REPLACE ENGINE SWITCH

B

END (COMMUNICATION ID REGISTRATION WAS DEFECTIVE)

3.REPLACE ENGINE SWITCH
a.

Replace the engine switch with a new one.

HINT:

for 1GR-FE:

Click hereEngine / Hybrid System>1GR-FE (STARTING)>ENGINE SWITCH>REMOVAL

for V35A-FTS:

Click hereEngine / Hybrid System>V35A-FTS (STARTING)>ENGINE SWITCH>REMOVAL

for F33A-FTV:

Click hereEngine / Hybrid System>F33A-FTV (STARTING)>ENGINE SWITCH>REMOVAL


Result:
Proceed to
NEXT




NEXT

END (ENGINE SWITCH WAS DEFECTIVE)