Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE PEDAL STROKE SENSOR (for LHD) › from 2021.07
RM38G0E _54 Brake _100463 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0467255 BRAKE PEDAL STROKE SENSOR(for LHD) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE PEDAL STROKE SENSOR(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
C455281N02
6.521,0.219 6.844,0.219 false 6.5,0.604 6.823,0.604 false 4.063,0.344 3.896,0.344 3.896,0.344 3.552,0.708 false 5.667,0.969 5.5,0.969 5.5,0.969 5.167,1.25 false 0.917,1.083 1.083,1.083 1.083,1.083 1.479,0.5 false 6.26,0.063 6.542,0.417 0.281,0.354 18 false 1 6.271,0.438 6.552,0.792 0.281,0.354 18 false 2 0.646,0.917 0.927,1.271 0.281,0.354 18 false 4 5.719,0.813 6,1.167 0.281,0.354 18 false 3 4.115,0.198 4.396,0.552 0.281,0.354 18 false 5 2.115,0.813 2.396,1.167 0.281,0.354 10 false x 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL - (Click here) - -
3 FRONT DOOR SCUFF PLATE LH 67914B - - -
4 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 55606 (Click here) - -
5 COWL SIDE TRIM BOARD LH 62112 - - -

C455192N01
5.375,3.729 5.625,3.729 false 5.792,2.615 6.125,2.865 0.333,0.25 10 false x 2 5.688,3.583 6.271,4 0.583,0.417 18 false 6

Procedure Part Name Code
Z101186

Z101188

Z101187

6 BRAKE PEDAL STROKE SENSOR ASSEMBLY 89510D - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake pedal stroke sensor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedures Necessary procedures Effect/Inoperative Function when Necessary Procedures are not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)
Brake pedal stroke sensor assembly* Perform "Calibration"
·

DTCs are stored

·

ABS warning light illuminates

·

Brake system warning light (yellow indicator) illuminates

·

Slip indicator light illuminates

·

Electronically controlled brake system does not operate correctly


(Click here)

HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -




PROCEDURE

Hide 1. PRECAUTION

Z101186

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





Hide 67914B 3.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 55606 4.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Z101186

Click here(Click here)

Hide 62112 5.REMOVE COWL SIDE TRIM BOARD LH

Hide 89510D 6.REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY

a.
C455200