| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | NO. 1 ENGINE UNDER COVER ASSEMBLY | 51410 | - | - | - |
| 2 | OIL PRESSURE SENDER GAUGE ASSEMBLY | 83520 | ( ) |
- | - |
| *1 | ENGINE SIDE COVER SUB-ASSEMBLY LH | *2 | ENGINE SIDE COVER SUB-ASSEMBLY RH |
| ★ | Precoated part | - | - |
To prevent burns, do not remove the oil pressure sender gauge assembly while the engine is hot.
51410 1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
83520 2.REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY
Disconnect the oil pressure sender gauge assembly connector.
Using a 27 mm deep socket wrench, remove the oil pressure sender gauge assembly.
If the oil pressure sender gauge assembly is dropped or subjected to a strong impact, replace it with a new one.