| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | NO. 1 ENGINE UNDER COVER ASSEMBLY | 51410 | - | - | - |
| 2 | NO. 2 ENGINE UNDER COVER ASSEMBLY | 51420 | - | - | - |
| *A | w/ Cover | *B | w/o Cover |
| *1 | ENGINE SIDE COVER SUB-ASSEMBLY LH | *2 | ENGINE SIDE COVER SUB-ASSEMBLY RH |
| ● | Non-reusable part | - | - |
To prevent burns, do not remove the engine oil level sensor while the engine is hot.
51410 1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
|
Bolt A |
|
Bolt B |
|
Remove in this Direction | - | - |
Remove the 5 bolts (A) and 4 bolts (B).
Move the side of the No. 1 engine under cover assembly facing the front of the vehicle toward the LH side and detach the temporary holding guide.
Remove the No. 1 engine under cover assembly facing the front of the vehicle while pulling the engine side cover sub-assembly RH and engine side cover sub-assembly LH, and then remove the No. 1 engine under cover assembly while detaching the 2 temporary holding guides facing the rear of the vehicle as shown in the illustration.
51420 2.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
3.DRAIN ENGINE OIL
12140 4.REMOVE OIL PAN COVER
89491 7.REMOVE ENGINE OIL LEVEL SENSOR
Disconnect the engine oil level sensor connector.
Remove the clip from the engine oil level sensor.
Remove the 2 bolts and engine oil level sensor.