19850 1.CHECK GLOW PLUG ASSEMBLY
for Bank 1
Remove the No. 1 glow plug connector.
Click hereEngine / Hybrid System>F33A-FTV (STARTING)>GLOW PLUG>REMOVAL
for Bank 2
Remove the No. 2 glow plug connector.
Click hereEngine / Hybrid System>F33A-FTV (STARTING)>GLOW PLUG>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Glow plug terminal - Body ground | 20°C (68°F) | Approximately 1.0 Ω |
If the result is not as specified, replace the glow plug assembly.
Be careful not to damage the glow plug assemblies, as this may cause an open circuit or shorten the life of the glow plug assemblies.
Do not allow oil or gasoline to contact the glow plug assembly when cleaning it.
Clean off any oil on the terminal with a dry cloth.
Do not apply more than 11 V to the glow plug assembly, as this may cause an open circuit.
for Bank 1
Install the No. 1 glow plug connector.
Click hereEngine / Hybrid System>F33A-FTV (STARTING)>GLOW PLUG>INSTALLATION
for Bank 2
Install the No. 2 glow plug connector.
Click hereEngine / Hybrid System>F33A-FTV (STARTING)>GLOW PLUG>INSTALLATION