| X0455 |
Steering Angle Sensor Wrong Installation |
History of steering sensor being installed incorrectly |
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly) Refer to Steering Angle Sensor Wrong Installation (X0455). ( ) |
| X204C |
Zero Point Calibration of Yaw Rate Sensor Undone |
History of incomplete yaw rate sensor zero point calibration |
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly) Refer to Zero Point Calibration of Yaw Rate Sensor Undone (X204C). ( ) |
| X2079 |
Communication Error from Brake Control Module to Engine Control Module |
History of being unable to send data to the ECM continuously for 2 seconds or more |
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
Refer to the following diagnosis procedure:
1.
Using the GTS, perform a Health Check.
2.
Refer to the flow chart(s) for the output DTCs.
|
| X2086 |
SRS Airbag Malfunction |
History of receiving a malfunction signal output for a secondary collision brake control request from the airbag sensor with ECU assembly 2 consecutive times |
- |
Output ECU: No. 2 skid control ECU (brake actuator assembly) Refer to How to Proceed with Troubleshooting in Airbag System. ( ) |
| X2087 |
Engine Malfunction |
History of receiving an engine control system malfunction signal continuously from the ECM for 1 second or more |
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly) Refer to How to Proceed with Troubleshooting in Engine Control System.
·
for 1GR-FE:( )
·
for V35A-FTS( )
·
for F33A-FTS (w/ DPF)
( )
·
for F33A-FTS (w/o DPF)
( )
|
| X2088 |
Bank Angle Detected |
History of VSC operation being temporarily prohibited when driving at a steep bank angle, etc. |
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
-
HINT:
-
Explain that VSC operation was temporarily prohibited when driving on a road with a steep bank angle, etc.
|
| X208A |
Zero Point Calibration of Steering Angle Sensor Initialization Malfunction |
History of being unable to obtain the steering angle zero point after driving at a vehicle speed exceeding 15 km/h (9 mph) for 0.05 seconds or more |
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
Refer to the following diagnosis procedure:
1.
Perform steering sensor zero point calibration.
|
| X208B |
EPB Motor Continuous Operation Request |
History of system suspended to prevent overheat of parking brake actuator assembly when electric parking brake was used repeatedly |
Brake hold operated indicator light blinks*1 |
Output ECU: No. 2 skid control ECU (brake actuator assembly)
-
HINT:
-
·
EPB: Electric Parking Brake System
·
Explain that system was suspended to prevent overheating of parking brake actuator assembly when electric parking brake was used repeatedly.
|
| X2096 |
Pre-Collision Brake |
History of pre-collision brake operation |
In accordance with Pre-collision System behavior |
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly) |
| X2098 |
Pre-Collision Brake Assist |
History of pre-collision brake assist operation |
In accordance with Pre-collision System behavior |
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly) |
| X20A0 |
ABS |
History of ABS operation |
Slip indicator light blinks |
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly) |
| X20A1 |
VSC |
History of VSC operation |
Slip indicator light blinks |
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly) |
| X20A2 |
TRC(TRAC) |
History of TRC operation |
Slip indicator light blinks |
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly) |
| X20A5 |
Hill Start Assist |
History of hill start assist operation |
- |
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly) |
| X20A7 |
Brake Assist |
History of brake assist operation |
- |
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly) |
| X20A8 |
Secondary Collision Brake |
History of secondary collision brake operation |
- |
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly) |
| X20A9 |
ABS Continuous Operation Request |
History of ABS being operated for 60 seconds or more |
·
Brake system warning light (yellow indicator) illuminates
·
Brake system warning light (red indicator) illuminates
·
ABS warning light illuminates
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly) |
| X20AA |
VSC Continuous Operation Request |
History of VSC being operated for 10 seconds or more |
·
Brake system warning light (yellow indicator) illuminates
·
Brake system warning light (red indicator) illuminates
·
ABS warning light illuminates
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly) |
| X20D7 |
Zero Point Calibration of Steering Angle Sensor Malfunction |
History of the steering sensor zero point calibration position differing from the stored value |
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly) Refer to Zero Point Calibration of Steering Angle Sensor Malfunction (X20D7). ( ) |
| X20D8 |
Zero Point Calibration of Steering Angle Sensor Not Acquired |
History of being unable to obtain the steering angle zero point |
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly) Refer to Zero Point Calibration of Steering Angle Sensor Not Acquired (X20D8). ( ) |
| X214F |
4WD High-Low Actuator Malfunction |
History of receiving an L4 malfunction signal output from the 4 wheel drive control ECU continuously for 2 seconds or more |
·
Brake system warning light (yellow indicator) illuminates
·
ABS warning light illuminates
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly) Refer to How to Proceed with Troubleshooting in Transfer System. ( ) |
| X219C |
EPB Lock Control Run |
History of abnormal EPB operation |
Brake system warning light (yellow indicator) illuminates |
Output ECU: No. 2 skid control ECU (brake actuator assembly)
-
HINT:
-
EPB: Electric Parking Brake System
|
| X21A9 |
ACC Low Pressure |
History of a continuous and significant decrease in accumulator pressure |
·
Brake system warning light (yellow indicator) illuminates
·
Brake system warning light (red indicator) illuminates
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) Refer to ACC Low Pressure (X21A9). ( ) |
| X21D0 |
Brake Pedal Position Sensor "A" Performance Malfunction |
History of malfunction of brake pedal stroke sensor 1 |
·
Brake system warning light (yellow indicator) illuminates
·
Brake system warning light (red indicator) illuminates
·
ABS warning light illuminates
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
Refer to the following diagnosis procedure:
1.
Using the GTS, perform a Health Check.
2.
Refer to the flow chart(s) for the output DTCs.
|
| X21D1 |
Brake Pedal Position Sensor "B" Performance Malfunction |
History of malfunction of brake pedal stroke sensor 2 |
·
Brake system warning light (yellow indicator) illuminates
·
Brake system warning light (red indicator) illuminates
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly)
Refer to the following diagnosis procedure:
1.
Using the GTS, perform a Health Check.
2.
Refer to the flow chart(s) for the output DTCs.
|
| X21D2 |
Brake Pressure Sensor / Brake Pedal Position Sensor Signal Compare Failure |
History of mismatch between brake pedal stroke sensor assembly and reaction force pressure sensor |
·
Brake system warning light (yellow indicator) illuminates
·
Brake system warning light (red indicator) illuminates
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) Refer to Brake Pressure Sensor / Brake Pedal Position Sensor Signal Compare Failure (X21D2). ( )
-
NOTICE:
-
If the detection conditions for X21D2 are met 3 times in a row in the same trip, DTC P05FF62 is stored.
-
( )
|
| X261B |
Software Inconsistency with PCS Module |
History of mismatch between the specification information sent by the forward recognition camera and the specification information stored in the No. 2 skid control ECU (brake actuator assembly) |
- |
Output ECU: No. 2 skid control ECU (brake actuator assembly)
Refer to the following diagnosis procedure:
1.
Using the GTS, perform a Health Check.
2.
Refer to the flow chart(s) for the output DTCs.
|
| XF01B |
ECU Security Key Not Registered |
ECU security key has not been registered |
*2 |
Output ECU: No. 2 skid control ECU (brake actuator assembly) ( ) |