| *1 | FUEL TANK FILLER PIPE | *2 | FUEL TANK FILLER PIPE ASSEMBLY |
| *3 | PIN | *4 | FUEL TANK BAND |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the fuel tank sub-assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
The fuel tank sub-assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank sub-assembly may fall off the engine lifter.
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
17420 3.REMOVE CENTER EXHAUST PIPE ASSEMBLY
77310A 4.REMOVE FUEL TANK CAP ASSEMBLY
77010 5.REMOVE FUEL TANK VENT TUBE ASSEMBLY
77606C 6.REMOVE NO. 2 FUEL TANK PROTECTOR
7.DISCONNECT NO. 1 FUEL TANK BREATHER TUBE SUB-ASSEMBLY
Detach the clamp and disconnect the No. 1 fuel tank breather tube sub-assembly from the fuel tank filler pipe assembly.
Click hereEngine / Hybrid System>F33A-FTV (FUEL)>FUEL SYSTEM>PRECAUTION
77213F 8.DISCONNECT FUEL TANK TO FILLER PIPE HOSE
9.DISCONNECT NO. 2 FUEL TANK BREATHER TUBE SUB-ASSEMBLY
Disconnect the No. 2 fuel tank breather tube sub-assembly from the fuel tank filler pipe.
Click hereEngine / Hybrid System>F33A-FTV (FUEL)>FUEL SYSTEM>PRECAUTION
77100U 10.REMOVE FUEL TANK SUB-ASSEMBLY
|
|
Using an engine lifter and attachments, support the fuel tank sub-assembly.
Remove the 2 bolts, 2 clips, 2 pins and 2 fuel tank bands.
Slightly lower the engine lifter.
77213F 11.REMOVE FUEL TANK TO FILLER PIPE HOSE
77697B 12.REMOVE NO. 3 FUEL TANK HEAT INSULATOR
Using a needle nose pliers, detach the 3 clips and remove the No. 3 fuel tank heat insulator from the fuel tank sub-assembly.