Home › Engine / Hybrid System › F33A-FTV (EMISSION CONTROL) › EGR COOLER › from 2021.07
RM38G0E _51 Engine / Hybrid System _106332 F33A-FTV EMISSION CONTROL _0491913 EGR COOLER A

F33A-FTV EMISSION CONTROL  EGR COOLER  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
A493020N03
6,0.833 6.167,0.833 6.167,0.833 6.333,1.333 true 3.99,0.708 4.25,0.417 4.25,0.417 4.417,0.417 true 4.385,3.333 4.635,3.583 4.635,3.583 4.802,3.583 true 1,3.458 1.167,3.458 1.167,3.458 1.333,2.844 true 2.083,2.833 2.333,3.083 2.333,3.083 2.5,3.083 true 0.75,1.167 0.917,1.167 0.917,1.167 1.208,2.156 true 0.5,1.573 0.667,1.573 0.667,1.573 0.833,1.844 true 1.917,0.917 2.083,0.917 2.083,0.917 2.333,1.583 true 1,0.719 1.167,0.719 1.167,0.719 1.417,1.719 true 2.979,1.198 3.188,1.198 3.188,1.198 3.323,1.406 true 4.115,2.479 4.354,2.729 4.354,2.729 4.531,2.729 true 5.438,2.729 5.25,2.729 5.25,2.729 5.083,2.417 true 3.135,2.781 3.385,3.031 3.385,3.031 3.552,3.031 true 5.802,0.698 6.083,1.052 0.281,0.354 18 false 1 4.5,0.281 4.781,0.635 0.281,0.354 18 false 2 4.969,3.448 5.25,3.802 0.281,0.354 18 false 3 0.792,3.323 1.073,3.677 0.281,0.354 18 false 4 2.594,3 3.208,3.198 0.615,0.198 10 false ● 0.594,1.083 1.208,1.281 0.615,0.198 10 false ● 0.333,1.458 0.615,1.813 0.281,0.354 18 false 5 1.729,0.781 2.01,1.135 0.281,0.354 18 false 6 3.604,2.906 3.885,3.26 0.281,0.354 18 false 7 0.844,0.625 1.458,0.823 0.615,0.198 10 false ● 2.823,1.115 3.438,1.313 0.615,0.198 10 false ● 4.594,2.635 5.208,2.833 0.615,0.198 10 false ● 5.5,2.646 6.115,2.844 0.615,0.198 10 false *1 5.698,2.167 6.042,2.406 0.344,0.24 10 false x 2 1.885,3.292 2.177,3.521 0.292,0.229 10 false x 2 0.75,2.729 1.063,2.948 0.313,0.219 10 false x 2 0.177,2.042 0.5,2.281 0.323,0.24 10 false x 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 NO. 2 EGR VALVE ASSEMBLY 25630 - - -
2 WATER BY-PASS PIPE 16268L - - -
3 NO. 11 WATER BY-PASS HOSE 16294 - - -
4 NO. 2 EGR PIPE 25611B - -
5 NO. 1 EGR PIPE 25611A - - -
6 NO. 1 EGR COOLER 25681 - - -
7 NO. 2 EGR COOLER 25682 - - -

*1 EGR valve adapter - -
● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the EGR valve removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)
Electric EGR control valve assembly Initialization - w/ DPF:
(Click here)
w/o DPF:
(Click here)

HINT:

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function when Necessary Procedure not Performed Necessary Procedure Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system


·

Learning completes when vehicle is operated normally

Effect/Inoperative Function when Necessary Procedure not Performed Necessary Procedure Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -



CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


PROCEDURE

Hide 25630 1.REMOVE NO. 2 EGR VALVE ASSEMBLY

Hide 16268L 2.REMOVE WATER BY-PASS PIPE

a.
A493008


Hide 16294 3.REMOVE NO. 11 WATER BY-PASS HOSE

a.
A493009


Hide 25611B 4.REMOVE NO. 2 EGR PIPE

a.
A493010


Hide 25611A 5.REMOVE NO. 1 EGR PIPE

a.
A493011


Hide 25681 6.REMOVE NO. 1 EGR COOLER

a.
A493012


Hide 25682 7.REMOVE NO. 2 EGR COOLER

a.
A493013