Home › Engine / Hybrid System › F33A-FTV (ENGINE CONTROL) › ECD SYSTEM (w/o DPF) › from 2021.07
RM38G0E _51 Engine / Hybrid System _106329 F33A-FTV ENGINE CONTROL _0484891 ECD SYSTEM(w/o DPF) C

F33A-FTV ENGINE CONTROL  ECD SYSTEM(w/o DPF)  P029907  Turbocharger/Supercharger "A" Underboost Condition Mechanical Failure  


DESCRIPTION

Refer to DTC P004518.

Click hereEngine / Hybrid System>F33A-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o DPF)>P004518

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note
P029907 Turbocharger/Supercharger "A" Underboost Condition Mechanical Failure The pressure is 55 kPa below the Target Boost Pressure for 20 seconds at an engine speed of 2800 to 4400 rpm.
(1 trip detection logic)
Turbocharger sub-assembly Comes on SAE Code: P0299

Related Data List
DTC No. Data List
P029907
·

Target VN Turbo Position Bank 1

·

Actual VN Turbo Position Bank 1

·

Target VN Turbo 2 Position*

·

Actual VN Turbo 2 Position*


HINT:

*: Valid only during Active Test "Control the VN Turbo 2 Position"



HINT:

If DTC P029907 is stored due to the variable nozzle being stuck open, the following symptoms may appear:

-

Lack of power

-

Vehicle surge or hesitation under light or medium load




CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P029907 Accelerate vehicle with accelerator depressed halfway or more starting from a speed of 120 km/h (75 mph) or more for 2 minutes (make sure gear is fixed and does not change)

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the turbocharger sub-assembly, calibrate the VN turbo offset voltage value and initialize the learning values after replacement.

Click hereEngine / Hybrid System>F33A-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o DPF)>REGISTRATION



HINT:
·

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

·

The state of the problem symptom can be determined by comparing the Data List items "Intake Manifold Absolute Pressure" and "Target Boost Pressure" while accelerating at a medium to high engine speed.



PROCEDURE

1.CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P029907)
a.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 372

b.

Read the DTCs.

Result:
Result Proceed to
DTC P029907 is output A
DTC P029907 and other DTCs are output B




A

2.PERFORM ACTIVE TEST USING GTS (OPERATE TURBOCHARGER SUB-ASSEMBLY)

B

GO TO DTC CHART

2.PERFORM ACTIVE TEST USING GTS (OPERATE TURBOCHARGER SUB-ASSEMBLY)
a.

Perform the Active Test.


b.

Bank 1:

Enter the following menus: Powertrain / Engine / Active Test / Test the Turbo Charger Step Motor Bank 1 / Data List / Target VN Turbo Position Bank 1 and Actual VN Turbo Position Bank 1.

Powertrain > Engine > Active Test
Active Test Display
Test the Turbo Charger Step Motor Bank 1
Data List Display
Target VN Turbo Position Bank 1
Actual VN Turbo Position Bank 1
50004 372 73 1125,1126

c.

Bank 2:

Enter the following menus: Powertrain / Engine / Active Test / Control the VN Turbo 2 Position / Data List / Target VN Turbo 2 Position and Actual VN Turbo 2 Position.

Powertrain > Engine > Active Test
Active Test Display
Control the VN Turbo 2 Position
Data List Display
Target VN Turbo 2 Position
Actual VN Turbo 2 Position
50004 372 100 1387,1388

d.

While changing the Active Test value to 10, 20, 30, 40, 30, 20 and 10%, check that Actual VN Turbo Position smoothly changes to the set opening amount.

NOTICE:

When moving the vanes toward the fully closed position, make sure that Actual VN Turbo Position does not become 5% or less.


OK:

The Actual VN Turbo Position value follows the Target VN Turbo Position.



Result:
Proceed to
OK
NG



OK

NG

REPLACE TURBOCHARGER SUB-ASSEMBLY
HINT:

Replace the malfunctioning turbocharger sub-assembly.


a.

Replace the No. 1 Turbocharger sub-assembly.

Click hereEngine / Hybrid System>F33A-FTV (INTAKE / EXHAUST)>TURBOCHARGER>REMOVAL


b.

Replace the No. 2 Turbocharger sub-assembly.

Click hereEngine / Hybrid System>F33A-FTV (INTAKE / EXHAUST)>TURBOCHARGER>REMOVAL