| *A | w/ Double Locking System | *B | w/o Double Locking System |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
|
MP grease | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 11 | REAR DOOR SERVICE HOLE COVER | 67842E | ( ) |
- | - |
| 12 | REAR DOOR GLASS INNER WEATHERSTRIP | 68174A | - | - | - |
| *A | w/ Courtesy Light | *B | w/ Reflex Reflector Assembly |
| *C | w/ Cover | - | - |
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
69780E 1.INSTALL REAR DOOR LOCK AND UNLOCK KNOB INSIDE LOCKING CABLE
69740E 2.INSTALL REAR DOOR LOCK OPEN LEVER REMOTE CONTROL CABLE
69038A 3.INSTALL REAR DOOR LOCK COVER SUB-ASSEMBLY
69318D 4.INSTALL DOOR LOCK WIRING HARNESS SEAL
|
|
69060A 5.INSTALL REAR DOOR LOCK WITH MOTOR ASSEMBLY
w/o Double Locking System:
|
Screw |
|
Connector |
|
MP grease |
|
Install in this Direction |
Apply MP grease to the sliding parts of the rear door lock with motor assembly.
Make sure that the rear door outside handle frame release plate is securely connected to the rear door lock with motor assembly.
Using a T30 "TORX" socket wrench, install the rear door lock with motor assembly with the screws.
Connect the connector.
w/ Double Locking System:
|
Screw |
|
Connector |
|
MP grease |
|
Install in this Direction |
Apply MP grease to the sliding parts of the rear door lock with motor assembly.
Make sure that the rear door outside handle frame release plate is securely connected to the rear door lock with motor assembly.
Using a T30 "TORX" socket wrench, install the rear door lock with motor assembly with the screws.
Connect the connector.
69038A 6.INSTALL DOOR LOCK COVER SET
67888F 8.INSTALL NO. 2 REAR DOOR WEATHERSTRIP
68152C 10.INSTALL REAR DOOR GLASS RUN
68174A 12.INSTALL REAR DOOR GLASS INNER WEATHERSTRIP
67674A 13.INSTALL REAR DOOR FRAME GARNISH
67604 14.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
67812C 15.INSTALL REAR DOOR HOLE COVER (w/ Cover)
81580C 16.INSTALL REFLEX REFLECTOR ASSEMBLY (w/ Reflex Reflector Assembly)
81230 17.INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)
18.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
67786D 19.INSTALL REAR DOOR TRIM UPPER COVER
20.CONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for 1GR-FE:
for V35A-FTS:
for F33A-FTV:
21. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
22.INITIALIZE POWER WINDOW CONTROL SYSTEM