| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | HEADLIGHT ASSEMBLY LH | - | - | - | - |
| 2 | HEADLIGHT BRACKET LH | - | - | - | - |
| 3 | HEADLIGHT CORD LH | - | - | - | - |
| 4 | HEADLIGHT ECU SUB-ASSEMBLY LH | 81056A | - | - | - |
| 5 | HEADLIGHT GASKET | 81134 | - | - | - |
| *1 | HEADLIGHT ECU LH | - | - |
| ● | Non-reusable part | - | - |
| *1 | HEADLIGHT HOUSING LH | *2 | BASE B ASSEMBLY |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the light control led ECU removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
1.REMOVE HEADLIGHT ASSEMBLY LH
81056A 2.REMOVE HEADLIGHT ECU SUB-ASSEMBLY LH
81156A 3.REMOVE HEADLIGHT BRACKET LH
81165 4.REMOVE HEADLIGHT CORD LH
81134 5.REMOVE HEADLIGHT GASKET
81176 6.REMOVE NO. 1 HEADLIGHT PROTECTOR LH
85967D 10.REMOVE LIGHT CONTROL LED ECU LH
|
|
|
Remove in this Direction | - | - |
|
Connector |
|
Screw |
Remove the 3 screws and detach the clamp.
Disconnect the 3 connectors.
Pull the base b assembly in the direction shown in the illustration.
Remove the 2 screws and detach the connector and remove the light control LED ECU LH.