The main body ECU (multiplex network body ECU) controls the operation of the following lights:
Front Door Inside Handle Illumination Light Assembly LH
Front Door Inside Handle Illumination Light Assembly RH
Rear Door Inside Handle Illumination Light Assembly LH
Rear Door Inside Handle Illumination Light Assembly RH
w/o Stop and Start System:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.
The DOME CUT relay supplies power to the interior lights. If all the lights that use power from the DOME CUT relay do not turn on, check the interior light auto cut circuit first.
Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>Interior Light Auto Cut Circuit
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Extended Illumination 2 | Operation of the following lights:
·
Front door inside handle illumination light assembly RH
·
Front door inside handle illumination light assembly LH
·
Rear door inside handle illumination light assembly RH
·
Rear door inside handle illumination light assembly LH |
OFF or ON | - |
| Tester Display |
|---|
| Extended Illumination 2 |
Door inside handle illumination light assembly turns on or off.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the N8 front door inside handle illumination light assembly LH connector.
Disconnect the M10 front door inside handle illumination light assembly RH connector.
Disconnect the P5 rear door inside handle illumination light assembly LH connector.
Disconnect the O5 rear door inside handle illumination light assembly RH connector.
Disconnect the I2 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(N8,I2)Location & Routingewd_type=routing;type=c,c;code=N8,I2 Click Connector(N8)Body>Front Door Wire LH>Front Door Inside Handle Illumination Light Assembly LHewd_type=component;type=c;code=N8;pinno=1 |
||
| N8-1 (-) - I2-14 (LED2) | Always | Below 1 Ω |
| N8-1 (-) or I2-14 (LED2) - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
A
B
C