Home › Engine / Hybrid System › 1HZ INTAKE / EXHAUST › EXHAUST MANIFOLD
RM25T0E _51 Engine / Hybrid System _029235 1HZ INTAKE / EXHAUST _0133247 EXHAUST MANIFOLD A

1HZ INTAKE / EXHAUST  EXHAUST MANIFOLD  INSTALLATION  


PROCEDURE

Hide 1.INSTALL EXHAUST MANIFOLD ASSEMBLY

a.
A326820

Install 2 new O-rings to the No. 2 exhaust manifold.


b.
A326822

Make sure the ends of the O-rings on the No. 2 exhaust manifold are facing opposite directions as shown in the illustration.


c.

Install the manifold collar to the exhaust manifold assembly.


d.

Install the No. 2 exhaust manifold to the exhaust manifold assembly.


e.
A326824C01
2.729,1.198 2.917,1.427 0.188,0.229 10 false .
V100135

Front


Install 2 new gaskets.

NOTICE:

Position the gaskets as shown illustrated.



f.

Install the exhaust manifold assembly with 12 new nuts.

Torque:
41.7 N*m (425 kgf*cm, 31 ft.*lbf)


Hide 17167 2.INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.

Install the No. 1 exhaust manifold heat insulator with the 5 bolts.

Torque:
18.1 N*m (185 kgf*cm, 13 ft.*lbf)


Hide 25620 3.INSTALL EGR VALVE ASSEMBLY (w/ EGR System)

Hide 17410 4.INSTALL FRONT EXHAUST PIPE ASSEMBLY

a.

Temporarily install the No. 1 exhaust pipe support to the front exhaust pipe assembly with the bolt.


b.

Install a new gasket and the front exhaust pipe assembly to the exhaust manifold assembly with 3 new nuts.

Torque:
54 N*m (551 kgf*cm, 40 ft.*lbf)


c.

Install a new gasket and the front exhaust pipe assembly to the center exhaust pipe assembly with 2 new bolts and 2 new nuts.

Torque:
48 N*m (489 kgf*cm, 35 ft.*lbf)


d.
A326816C03
2.833,1.688 2.906,1.854 2.906,1.854 3.073,1.854 false 1.469,1.854 1.667,1.854 1.667,1.854 1.865,1.479 true 1.969,0.219 2.219,0.219 2.219,0.219 2.469,0.479 true 1.323,1.75 1.635,1.906 0.313,0.156 10 true *1 1.802,0.115 2.115,0.271 0.313,0.156 10 true *2 3.115,1.771 3.427,1.927 0.313,0.156 10 true *3
*1 No. 1 Exhaust Pipe Support
*2 Front Exhaust Pipe Assembly
*3 Exhaust Pipe Support Bracket Bolt


Install the No. 1 exhaust pipe support bracket to the cylinder block sub-assembly with the 2 bolts.

Torque:
24 N*m (245 kgf*cm, 18 ft.*lbf)


e.

Tighten the exhaust pipe support bracket bolt.

Torque:
19.5 N*m (199 kgf*cm, 14 ft.*lbf)


Hide 17705 5.INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE