Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › CAMSHAFT
RM25T0E _51 Engine / Hybrid System _029355 1HZ ENGINE MECHANICAL _0133479 CAMSHAFT A

1HZ ENGINE MECHANICAL  CAMSHAFT  REMOVAL  


PROCEDURE

Hide 13523P 1.REMOVE CAMSHAFT TIMING PULLEY

Hide 11385 2.REMOVE CAMSHAFT OIL SEAL RETAINER

a.
A326333

Remove the 4 bolts holding the camshaft oil seal retainer to the cylinder head sub-assembly.


b.
A326334C01
1.073,1.531 1.198,1.531 1.198,1.531 1.365,0.917 true 0.896,1.438 1.156,1.646 0.26,0.208 10 false *a
*a Protective Tape


Pry out the camshaft oil seal retainer.

HINT:

Tape the screwdriver tip before use.



Hide 13511 4.REMOVE CAMSHAFT

a.
A326335N01
2.938,0.01 3.063,0.208 0.125,0.198 10 false 1 3.292,0.208 3.406,0.406 0.115,0.198 10 false 2 0.25,0.906 0.375,1.104 0.125,0.198 10 false 3 0.677,1.917 0.802,2.115 0.125,0.198 10 false 4 2.552,0.125 2.677,0.323 0.125,0.198 10 false 5 2.917,1.073 3.042,1.271 0.125,0.198 10 false 6 0.885,0.698 1.01,0.896 0.125,0.198 10 false 7 1.281,1.688 1.406,1.885 0.125,0.198 10 false 8 2.208,0.25 2.333,0.448 0.125,0.198 10 false 9 2.521,1.208 2.719,1.406 0.198,0.198 10 false 10 1.24,0.552 1.438,0.75 0.198,0.198 10 false 11 1.719,1.5 1.917,1.698 0.198,0.198 10 false 12 1.656,0.417 1.854,0.615 0.198,0.198 10 false 13 2.125,1.344 2.323,1.542 0.198,0.198 10 false 14

Uniformly loosen and remove the 14 bearing cap bolts in several passes in the sequence shown.


b.

Remove the No. 1 camshaft bearing cap, 6 No. 2 camshaft bearing caps and camshaft.


c.

Remove the 2 camshaft bearings from the No. 1 bearing cap and No. 1 journal of the cylinder head sub-assembly.


d.

Remove the camshaft thrust plate.

HINT:

Arrange the No. 1 camshaft bearing cap, No. 2 camshaft bearing caps and camshaft bearings in correct order.