Home › Engine / Hybrid System › 1HZ (LUBRICATION) › LUBRICATION SYSTEM
RM25T0E _51 Engine / Hybrid System _029209 1HZ LUBRICATION _0133935 LUBRICATION SYSTEM G

1HZ LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT OIL QUALITY

a.

Check the engine oil for deterioration, water contamination, discoloration or thinning.

If the quality is visibly poor, replace the engine oil and oil filter sub-assembly.

Click hereEngine / Hybrid System>1HZ (LUBRICATION)>OIL AND OIL FILTER>REPLACEMENT


Hide 2.INSPECT ENGINE OIL LEVEL

a.

Warm up the engine, stop the engine and wait 5 minutes. The engine oil level should be between the engine oil level dipstick low level mark and full level mark.

If low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not fill engine oil above the full level mark.


HINT:

A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.

·

When the engine is new, for example directly after purchasing the vehicle or after replacing the engine.

·

If low quality oil or oil of an inappropriate viscosity is used.

·

When driving at high engine speed or with a heavy load, when towing, or when driving while accelerating or decelerating frequently.

·

When idling for a long time, or when driving frequently through heavy traffic.


When judging the amount of oil consumption, keep in mind that the oil may have become diluted, making it difficult to judge the true level accurately.



Hide 3.INSPECT ENGINE OIL PRESSURE

a.

Remove the engine oil pressure switch assembly or oil pressure sender gauge assembly.

·

for Engine Oil Pressure Switch Assembly:

Click hereEngine / Hybrid System>1HZ (LUBRICATION)>OIL PRESSURE SWITCH>REMOVAL

·

for Oil Pressure Sender Gauge Assembly:

Click hereEngine / Hybrid System>1HZ (LUBRICATION)>OIL PRESSURE SENSOR>REMOVAL



b.
A326395C01
1.656,1.615 1,2.083 1,2.083 0.833,2.083 true 2.698,0.396 2.417,0.167 2.417,0.167 2.25,0.167 true 2.094,0.063 2.406,0.219 0.313,0.156 10 false *a 0.677,1.979 0.99,2.135 0.313,0.156 10 false *b
*a Oil Pressure Gauge
*b Adapter


Install an oil pressure gauge with an adapter.


c.

Warm up the engine.


d.

Measure the engine oil pressure.

Standard Oil Pressure:
Condition Specified Condition
Idle 29 kPa (0.3 kgf/cm2, 4.2 psi) or higher
3000 rpm 245 kPa (2.5 kgf/cm2, 36 psi) or higher


If the pressure is not as specified, check the oil pump.


e.

Remove the oil pressure gauge and adapter.


f.

Install the engine oil pressure switch assembly or oil pressure sender gauge assembly.

·

for Engine Oil Pressure Switch Assembly:

Click hereEngine / Hybrid System>1HZ (LUBRICATION)>OIL PRESSURE SWITCH>INSTALLATION

·

for Oil Pressure Sender Gauge Assembly:

Click hereEngine / Hybrid System>1HZ (LUBRICATION)>OIL PRESSURE SENSOR>INSTALLATION