The speed sensor detects the wheel speed and sends the appropriate signals to the skid control ECU. The skid control ECU converts these wheel speed signals into a 4-pulse signal and outputs it to the ECM via the combination meter. The ECM determines the vehicle speed based on the frequency of these pulse signals.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0500 | Vehicle Speed Sensor "A" | When one of the following conditions is met:
·
Following conditions (a), (b), (c) and (d) met for 8 seconds or more: (2 trip detection logic)
(a)
Engine coolant temperature more than 70°C (158°F)
(b)
Engine speed between 1500 rpm and 4000 rpm
(c)
Vehicle running
(d)
No speed signal input to ECM
·
Following conditions (a), (b) and (c) met for 5 seconds or more:
(a)
Vehicle running
(b)
Under fuel-cut operation
(c)
No speed signal is input to ECM |
·
Open or short in speed signal circuit
·
Brake actuator assembly
·
Combination meter
·
ECM |
Comes on | DTC stored |
After replacing the ECM, the new ECM needs registration (See page Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (See page Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Drive the vehicle and check whether the operation of the speedometer in the combination meter is normal.
The vehicle speed sensor is operating normally if the speedometer reading is normal.
The vehicle speed sensor is operating normally.
| Proceed to |
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the ignition switch ON and start the engine.
Turn the GTS ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Vehicle Speed.
| Tester Display |
|---|
| Vehicle Speed |
Drive the vehicle.
Read the value displayed on the GTS.
Vehicle speeds displayed on tester and speedometer display are equal.NG
| Proceed to |
| OK |
| NG |
OK
Click hereEngine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM>CHECK FOR INTERMITTENT PROBLEMS
NG
Disconnect the L25 combination meter connector.
Disconnect the A29 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L25-8 (+S) - A29-8 (SPD) | Always | Below 1 Ω |
| L25-8 (+S) or A29-8 (SPD) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
| OK |
| NG |
OK
NG