| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0606 | ECM / PCM Processor | ECM internal error (1 trip detection logic) |
ECM | Comes on | DTC stored |
| P0607 | Control Module Performance | ECM internal error (1 trip detection logic) |
ECM | Comes on | DTC stored |
| P1611 | IC Circuit Malfunction | ECM internal error (1 trip detection logic) |
ECM | Comes on | DTC stored |
After replacing the ECM, the new ECM needs registration (See page Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (See page Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch ON and turn the GTS ON.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
|---|---|
| P0606 or P0607 or P1611 is output | A |
| P0606 or P0607 or P1611 and other DTCs are output | B |
A
B