To detect atmospheric pressure, the built-in atmospheric pressure sensor in the ECM is used for the common rail system. Following the changes in the atmospheric pressure, the ECM corrects the fuel injection volume, timing and duration, and adjusts the common rail internal fuel pressure in order to optimize engine combustion.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P2226 | Barometric Pressure Circuit | Atmospheric pressure sensor malfunction (1 trip detection logic) |
ECM | Comes on | DTC stored |
| P2228 | Barometric Pressure Circuit Low Input | Atmospheric pressure sensor malfunction (1 trip detection logic) |
ECM | Comes on | DTC stored |
| P2229 | Barometric Pressure Circuit High Input | Atmospheric pressure sensor malfunction (1 trip detection logic) |
ECM | Comes on | DTC stored |
After replacing the ECM, the new ECM needs registration (See page Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (See page Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch ON and turn the GTS ON.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
|---|---|
| P2226, P2228 or P2229 is output | A |
| P2226, P2228 or P2229 and other DTCs are output | B |
If any DTCs other than P2226, P2228 and P2229 are output, troubleshoot those DTCs first.
A
B