DESCRIPTION
When troubleshooting a vehicle with the diagnosis system, the only difference from the usual troubleshooting procedure is connecting the GTS to the vehicle and reading various data output from the vehicle's brake actuator assembly (skid control ECU).
The brake actuator assembly (skid control ECU) records DTCs when the ECU detects a malfunction in the ECU itself or in its circuits. To check the DTCs, connect the GTS to the DLC3 on the vehicle.
The GTS enables you to clear the DTCs, activate the various actuators, and check the freeze frame data and Data List.
Check the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge the battery before proceeding to the diagnosis.
DIAGNOSIS
If the brake actuator assembly (skid control ECU) detects a malfunction, the ABS warning light will come on to warn the driver.
The DTCs are simultaneously stored in memory.
The DTCs can be read by connecting SST between terminals TC and CG of the DLC3 and observing the blinking pattern of the ABS warning light, or by connecting the GTS.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR
This system has a Test Mode (signal check) function.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE