The brake actuator assembly (skid control ECU) measures the speed of each wheel by receiving signals from the speed sensors.
These signals are used for recognizing that all 4 wheels are operating properly.
Therefore, all wheel signals must indicate the same speed.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1337 | Diameter of the Tire is not Uniform | The following occurs in 3 consecutive trips: At a vehicle speed of 20 km/h (12 mph) or more, there is a difference of 20% or more in the average speed between the front wheels and rear wheels for 20 seconds or more. |
·
Tire and wheel size
·
Tire deformation
·
Speed sensor rotor
·
Speed sensor
·
Speed sensor circuit
·
Brake actuator assembly (Skid control ECU) |
When DTCs C1401 to C1416 are output with DTC C1337, inspect and repair the trouble areas indicated by DTCs C1401 to C1416 first.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
Check the size and condition of all 4 wheels.
The DTC is output when tire deformation or a difference in tire size is detected.
The diameter and air pressure of all 4 tires are the same.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.
Check if the same DTC is output.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC is output |
| DTC is not output |
DTC is output
DTC is not output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING