Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1GR-FE)
RM25T0E _55 Steering _029920 POWER ASSIST SYSTEMS _0136925 VANE PUMP(for 1GR-FE) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1GR-FE)  INSTALLATION  


PROCEDURE

Hide 44310 1.INSTALL VANE PUMP ASSEMBLY

a.

Install the vane pump assembly with the 2 bolts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 2.INSTALL WIRE HARNESS BRACKET

a.

Install the wire harness bracket with the bolt.

Torque:
40 N*m (408 kgf*cm, 30 ft.*lbf)


Hide 44410 3.CONNECT PRESSURE FEED TUBE ASSEMBLY

a.
C312594C01
2.281,1.906 2.01,1.615 true 2.323,1.906 2.635,2.104 0.313,0.198 10 false *a
*a Stopper


Install a new gasket to the pressure feed tube assembly.


b.

Connect the pressure feed tube with the union bolt.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)

HINT:

Make sure that the stopper of the tube touches the vane pump assembly body as shown in the illustration, then tighten the union bolt.



Hide 4.CONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR

a.

Connect the power steering oil pressure switch connector.


Hide 44348A 5.CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

a.

Connect the No. 1 oil reservoir to pump hose to the vane pump assembly, and slide the clip to secure it.


Hide 16361A 6.INSTALL FAN AND GENERATOR V BELT

Hide 17801 8.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17705 9.INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE

Hide 10.ADD POWER STEERING FLUID

Hide 12.INSPECT FOR POWER STEERING FLUID LEAK

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL