Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (except 1GR-FE) › 2014.08–2019.09
RM25T0E _55 Steering _029920 POWER ASSIST SYSTEMS _0137065 VANE PUMP(except 1GR-FE) A

POWER ASSIST SYSTEMS  VANE PUMP(except 1GR-FE)  INSTALLATION  


PROCEDURE

Hide 44310 1.INSTALL VANE PUMP ASSEMBLY

a.

Coat a new O-ring with MP grease and install it to the vane pump assembly.


b.

Install the vane pump assembly with the 2 nuts.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


Hide 44410 2.CONNECT PRESSURE FEED TUBE ASSEMBLY

a.

Install a new gasket to the pressure feed tube assembly.


b.
C308173C01
1.833,3.302 2.25,2.885 true 1.854,1.01 2.271,0.594 true 0.229,0.167 0.542,0.323 0.313,0.156 10 false *A 0.25,2.365 0.563,2.521 0.313,0.156 10 false *B 2.271,2.771 2.583,2.927 0.313,0.156 10 false *a 2.313,0.479 2.625,0.635 0.313,0.156 10 false *a
*A for 1VD-FTV
*B for 1HZ
*a Stopper


Connect the pressure feed tube assembly with the union bolt.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)

HINT:

Make sure that the stopper of the tube touches the vane pump assembly body as shown in the illustration, then tighten the union bolt.



Hide 3.CONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR (for 1VD-FTV)

a.

Connect the power steering oil pressure switch connector.


Hide 44348A 4.CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

a.

Connect the No. 1 oil reservoir to pump hose to oil reservoir, and slide the clamp to secure it.


Hide 16470 5.INSTALL RADIATOR RESERVE TANK ASSEMBLY (for 1VD-FTV)

Hide 17705 8.INSTALL AIR CLEANER CAP SUB-ASSEMBLY (for 1VD-FTV)

Hide 10.BLEED AIR FROM POWER STEERING SYSTEM