Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for 1VD-FTV)
RM25T0E _58 Vehicle Interior _029469 HEATING / AIR CONDITIONING _0137769 COMPRESSOR(for 1VD-FTV) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 1VD-FTV)  INSTALLATION  


PROCEDURE

Hide 1.ADJUST COMPRESSOR OIL

a.

When replacing the compressor assembly with magnet clutch with a new one, gradually discharge the refrigerant gas from the service valve, and drain the following amount of oil from the new compressor assembly with magnet clutch before installation.

Standard:

(Oil capacity inside the new compressor assembly with magnet clutch: 130 + 15 cc (4.6 + 0.51 fl.oz.)) - (Remaining oil amount in the removed compressor assembly with magnet clutch) = (Oil amount to be removed from the new compressor when replacing)


NOTICE:
·

When checking the compressor oil level, follow the A/C system's precautions.

·

If a new compressor assembly with magnet clutch is installed without removing some oil remaining in the pipes of the vehicle, the oil amount will be too large. This prevents heat exchange in the refrigerant cycle and causes refrigerant failure.

·

If the volume of oil remaining in the removed compressor assembly with magnet clutch is too small, check for oil leakage.

·

Be sure to use ND-OIL 8 or equivalent for compressor oil.




Hide 2.INSTALL COMPRESSOR ASSEMBLY WITH MAGNET CLUTCH

E147502

a.

Install the compressor assembly with magnet clutch with the 4 bolts.

Torque:
24 N*m (245 kgf*cm, 18 ft.*lbf)


Hide 88712 3.CONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE

a.

Remove the attached vinyl tape from the No. 1 cooler refrigerant suction hose.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor assembly with magnet clutch.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring on the No. 1 cooler refrigerant suction hose.


d.

Connect the No. 1 cooler refrigerant suction hose on the compressor assembly with magnet clutch with the bolt.

Torque:
9.5 N*m (97 kgf*cm, 84 in.*lbf)


Hide 88711 4.CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

a.

Remove the attached vinyl tape from the No. 1 cooler refrigerant discharge hose.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor assembly with magnet clutch.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring on the No. 1 cooler refrigerant discharge hose.


d.

Connect the No. 1 cooler refrigerant discharge hose on the compressor assembly with magnet clutch with the bolt.

Torque:
9.5 N*m (97 kgf*cm, 84 in.*lbf)


Hide 16400 5.INSTALL RADIATOR ASSEMBLY

Hide 16361A 6.INSTALL FAN AND GENERATOR V BELT

Hide 7.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT

Hide 9.CHECK FOR REFRIGERANT GAS LEAK