Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR
RM25T0E _58 Vehicle Interior _029469 HEATING / AIR CONDITIONING _0137764 FRONT EVAPORATOR TEMPERATURE SENSOR A

HEATING / AIR CONDITIONING  FRONT EVAPORATOR TEMPERATURE SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 88625 1.INSTALL NO. 1 COOLER THERMISTOR

a.
E304583C01
1.125,0.656 1.104,0.365 1.104,0.365 0.969,0.365 false 1.656,1.01 1.854,1.01 false 0.813,0.313 1.125,0.469 0.313,0.156 10 false *1 1.875,0.938 2.188,1.094 0.313,0.156 10 false *2 1.281,0.313 1.594,0.469 0.313,0.156 10 false *a 2.865,2.438 3.177,2.594 0.313,0.156 10 false *b 2.146,1.813 2.385,1.958 0.24,0.146 10 true *c 2.198,3.021 2.51,3.177 0.313,0.156 10 false *d
*1 Plastic Case
*2 No. 1 Cooler Thermistor
*a Range A
*b 50.0 mm (1.9685 in.) (from tank upper surface)
*c 89.6 mm (3.5276 in.) (from end face of No. 1 cooler evaporator sub-assembly)
*d 76.2 mm (3.0000 in.) (from end face of No. 1 cooler evaporator)


Install the No. 1 cooler thermistor as shown in the illustration.

NOTICE:
·

Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.

·

When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (A in the illustration).

·

After inserting the thermistor, do not apply excessive force to the wire.

·

Directly insert the thermistor until the edge of the plastic case comes into contact with the evaporator.




Hide 88501 2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

Hide 88515 3.INSTALL COOLER EXPANSION VALVE

Hide 87103B 4.INSTALL BLOWER WITH FAN MOTOR SUB-ASSEMBLY