Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
73220 1.INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH
| *1 | Bolt A |
| *2 | Bolt B |
Attach the guide and temporarily install the front seat outer belt assembly LH with the bolt (A) and (B).
Tighten the bolt (A).
Tighten the bolt (B).
Connect the shoulder anchor of the front seat outer belt assembly LH with the bolt.
Attach the 2 claws to close the front seat outer belt shoulder anchor cover.
Connect the front seat outer belt floor anchor with the bolt.
Check that the front seat outer belt is not twisted.
62512 2.INSTALL QUARTER INSIDE TRIM BOARD LH (for RH Side)
Attach the 12 clips to install the quarter inside trim board LH.
87123 3.INSTALL HEATER KNOB (for Rear Heater)
62511 4.INSTALL QUARTER INSIDE TRIM BOARD RH (for RH Side)
73299 5.INSTALL NO. 2 QUARTER TRIM BELT HOLE COVER LH (w/ Rear No. 1 Seat)
Install the No. 2 quarter trim belt hole cover with the 2 screws.
73298B 6.INSTALL QUARTER TRIM BELT HOLE COVER LH
Install the quarter trim belt hole cover with the 2 screws.
58796A 7.INSTALL JACK CLAMP HOOK (for RH Side)
09114 8.INSTALL JACK HANDLE EXTENSION SUB-ASSEMBLY (for RH Side)
09115 9.INSTALL JACK HANDLE ROD SUB-ASSEMBLY (for RH Side)
10.INSTALL REAR SIDE SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)