Home › Vehicle Interior › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY(for Long Body)
RM25T0E _58 Vehicle Interior _029931 SEAT BELT _0142843 REAR SEAT OUTER BELT ASSEMBLY(for Long Body) A

SEAT BELT  REAR SEAT OUTER BELT ASSEMBLY(for Long Body)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 73370 1.INSTALL REAR SEAT OUTER 3 POINT TYPE BELT ASSEMBLY LH

a.

Attach the 3 guides and temporarily install the rear seat outer 3 point type belt assembly LH with the bolt.


b.

Tighten the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


c.

Connect the shoulder anchor of the rear seat outer 3 point type belt assembly LH with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


d.

Attach the 2 claws to close the rear seat outer 3 point type belt shoulder anchor cover.


e.

Connect the rear seat outer 3 point type belt floor anchor with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


f.

Check that the rear seat outer 3 point type belt is not twisted.


Hide 62512 2.INSTALL QUARTER INSIDE TRIM BOARD LH

a.

Attach the 12 clips to install the quarter inside trim board LH.


Hide 62511 4.INSTALL QUARTER INSIDE TRIM BOARD RH (for RH Side)

Hide 73299 5.INSTALL NO. 2 QUARTER TRIM BELT HOLE COVER LH (w/ Rear No. 1 Seat)

a.

Install the No. 2 quarter trim belt hole cover with the 2 screws.


Hide 73298B 6.INSTALL QUARTER TRIM BELT HOLE COVER LH

a.

Install the quarter trim belt hole cover with the 2 screws.


Hide 09114 8.INSTALL JACK HANDLE EXTENSION SUB-ASSEMBLY (for RH Side)

Hide 09115 9.INSTALL JACK HANDLE ROD SUB-ASSEMBLY (for RH Side)

Hide 10.INSTALL REAR SIDE SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)