1.INSPECT LOCK PLATE
| *a | Lock Plate |
| *1 | Radiator Core |
Inspect the lock plate for damage.
If the sides of the lock plate groove are deformed, reassembly of the tank will be impossible. Correct any deformations with pliers.
Water will leak if the bottom of the lock plate groove is damaged or dented. Repair or replace it if necessary.
The radiator assembly can only be recaulked twice. After the second time, the radiator core must be replaced.
16210 2.INSPECT FLUID COUPLING ASSEMBLY
Remove the fan with fluid coupling.
Click hereEngine / Hybrid System>1GR-FE (COOLING)>RADIATOR>REMOVAL
Remove the 4 nuts and fan from the fluid coupling assembly.
Turn the fluid coupling and check that the bearing moves smoothly and quietly.
If necessary, replace the fluid coupling assembly.
Check that the fluid coupling assembly is not damaged and that no silicon oil leaks.
If necessary, replace the fluid coupling assembly.
Install the fan to the fluid coupling assembly with the 4 nuts.
Install the fan with fluid coupling.
Click hereEngine / Hybrid System>1GR-FE (COOLING)>RADIATOR>INSTALLATION