Home › Drivetrain › H152F (MANUAL TRANSMISSION / TRANSAXLE) › BACK-UP LIGHT SWITCH › from 2016.08
RM25T0E _52 Drivetrain _058021 H152F MANUAL TRANSMISSION / TRANSAXLE _0282326 BACK-UP LIGHT SWITCH A

H152F MANUAL TRANSMISSION / TRANSAXLE  BACK-UP LIGHT SWITCH  INSTALLATION  


PROCEDURE

Hide 84210 1.INSTALL BACK-UP LIGHT SWITCH ASSEMBLY

a.
C312642C01
0.792,0.438 1.073,0.438 1.073,0.438 1.49,0.99 false 2.292,0.25 1.979,0.25 1.979,0.25 1.677,0.813 false 2.344,0.844 2.656,1.042 0.313,0.198 10 false *a 0.417,0.365 0.875,0.563 0.458,0.198 10 false SST 2.406,0.167 2.865,0.365 0.458,0.198 10 false SST
*a Torque Wrench Fulcrum Length


Using SST, install a new gasket and the back-up light switch assembly to the transmission case.

SST
09817-16011  09961-01270  

Torque:
Specified tightening torque : 44.1 N*m (450 kgf*cm, 33 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 200 mm (7.8740 in.)) + torque wrench (fulcrum length of 380 mm (14.9606 in.)): 28.9 N*m (295 kgf*cm, 21 ft.*lbf)




b.
C364405

Connect the back-up light switch connector clamp to the wire harness clamp bracket.


c.

Set the wire harness to the wire harness clamp bracket and close the clamp to secure it as shown in the illustration.

NOTICE:

Lightly pull the wire harness toward the wire harness clamp bracket side and after placing the wire harness slack at the connector side, secure it by bending the clamp of the wire harness clamp bracket.



d.

Connect the back-up light switch connector.