Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.INSTALL STEERING COLUMN ASSEMBLY
w/o Driver Side Knee Airbag:
Install the steering column assembly with the 2 nuts and bolt.
w/ Driver Side Knee Airbag:
Install the steering column assembly and new steering shaft thrust stopper with the 2 nuts and bolt.
| *A | w/o Driver Side Knee Airbag |
| *B | w/ Driver Side Knee Airbag |
| *a | Matchmark |
Align the matchmarks on the steering intermediate shaft and steering column assembly.
Install the bolt.
Attach the 2 wire harness clamps to the steering column assembly.
55844 2.INSTALL NO. 2 HEATER TO REGISTER DUCT
Install the No. 2 heater to register duct with the clip.
73900 3.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)
55480D 4.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
84306 5.INSTALL COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
Using pliers, grip the claws of the clamp and install the combination switch assembly with spiral cable sub-assembly to the steering column assembly with the clamp.
Connect the connectors.
45286B 6.INSTALL UPPER STEERING COLUMN COVER
Attach the claw to install the upper steering column cover.
45287 7.INSTALL LOWER STEERING COLUMN COVER
Attach the 2 claws to install the lower steering column cover.
Install the 2 screws.
8.ADJUST SPIRAL CABLE SUB-ASSEMBLY
45100 9.INSTALL STEERING WHEEL ASSEMBLY
10.CHECK FRONT WHEELS FACING STRAIGHT AHEAD