41101 1.INSTALL REAR DIFFERENTIAL CARRIER SUB-ASSEMBLY
Clean the contact surfaces of the rear differential carrier sub-assembly and axle housing.
Be careful not to damage the installation surface.
Install the rear differential carrier sub-assembly, and a new gasket and the washers with the 10 nuts.
Be careful to install the gasket without tearing it.
2.INSTALL WIRE HARNESS CLAMP BRACKET (w/ ABS,VSC)
Install the wire harness clamp bracket with the nut.
Connect the clamp.
3.INSTALL REAR AXLE SHAFT ASSEMBLY
4.ADD DIFFERENTIAL OIL
37110 5.INSTALL PROPELLER SHAFT ASSEMBLY