Home › Engine / Hybrid System › 1VD-FTV (EMISSION CONTROL) › EXHAUST FUEL ADDITION INJECTOR (for DPF) › 2016.08–2022.09
RM25T0E _51 Engine / Hybrid System _029525 1VD-FTV EMISSION CONTROL _0290816 EXHAUST FUEL ADDITION INJECTOR(for DPF) A

1VD-FTV EMISSION CONTROL  EXHAUST FUEL ADDITION INJECTOR(for DPF)  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines.

Click hereEngine / Hybrid System>1VD-FTV (EMISSION CONTROL)>EMISSION CONTROL SYSTEM (w/ DPF)>ON-VEHICLE INSPECTION


PROCEDURE

Hide 23255B 1.INSTALL FUEL INJECTOR SEAL

a.

Install a new fuel injector seal to the exhaust fuel addition injector assembly.


Hide 23710B 2.INSTALL EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

NOTICE:

If there is foreign matter on the installation surface of the exhaust fuel addition injector assembly, be sure to clean it before installation.


a.
A201785C06
2.344,0.75 2.188,0.75 2.188,0.75 1.969,1.01 true 2.385,0.667 2.573,0.823 0.188,0.156 10 false *1
*1 Nozzle Holder Clamp


Install a new gasket, the exhaust fuel addition injector assembly, nozzle holder clamp and a new washer with the bolt.

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)

HINT:

Align the nozzle holder clamp with the cutouts of the exhaust fuel addition injector assembly as shown in the illustration.



Hide 23901H 3.CONNECT FUEL TUBE SUB-ASSEMBLY

a.

Connect the fuel tube connector to the exhaust fuel addition injector assembly.


b.
A203842C05
1.781,2.573 1.917,2.573 1.917,2.573 1.917,2.865 false 2.531,2.979 2.531,2.729 2.531,2.729 2.635,2.729 false 2.271,3.51 2.271,3.854 2.271,3.854 2.417,3.854 false 1.917,3.323 1.917,4 false 2.688,2.646 2.865,2.802 0.177,0.156 10 false *1 1.594,2.479 1.906,2.635 0.313,0.156 10 false *a 2.469,3.771 2.781,3.927 0.313,0.156 10 false *b 1.854,4.042 2.167,4.198 0.313,0.156 10 false *c
*1 Exhaust Fuel Addition Injector
*a Fuel Tube Connector
*b Retainer
*c O-Ring


Turn the retainer in the direction indicated by the arrow until they make a "click" sound.

NOTICE:
·

If the fuel tube connector is not inserted to the correct position on the exhaust fuel addition injector assembly, the retainer cannot be turned far enough in the direction of the arrow.

·

Before connecting the fuel tube connector and fuel pipe, check that there is no damage or foreign matter on the connecting part of the fuel pipe.

·

After connecting the fuel tube connector and fuel pipe, check that they are securely connected by trying to pull them apart.




c.

Connect the exhaust fuel addition injector connector.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL