The ECM stores this DTC when a communication line between the ECM and transponder key ECU assembly is malfunctioning or the communication ID of the ECM and transponder key ECU assembly do not match.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2799 | Engine Immobiliser System Malfunction | One of the following conditions is met:
·
Error in communication between ECM and transponder key ECU assembly.
·
Error in communication lines.
·
Communication ID is different during communication between ECM and transponder key ECU assembly. |
·
Harness or connector
·
Transponder key ECU assembly
·
ECM |
DTC Output Confirmation Operation:
·
Start the engine and wait 10 seconds.
·
After disconnecting and reconnecting the cable to the negative (-) battery terminal, turn the ignition switch to ON and wait 10 seconds. |
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started | - |
| DTC No. | Data List and Active Test |
|---|---|
| B2799 | - |
If the transponder key ECU assembly or ECM is replaced, refer to Service Bulletin.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
If transponder key ECU assembly DTCs are output simultaneously, troubleshoot the transponder key ECU assembly DTCs first.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
DTC B2799 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Reregister the ECU communication ID.
Refer to Service Bulletin.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Perform "DTC Output Confirmation Operation" procedure.
Check for DTCs.
B2799 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Check that the connectors are properly connected to the ECM and transponder key ECU assembly.
Connectors are properly connected.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the L30 transponder key ECU assembly connector.
Disconnect the I84*1 or A29*2, *3 ECM connector.
*1: for 1GR-FE, LHD
*2: for 1GR-FE, RHD
*3: for 1VD-FTV
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L30-12 (EFII) - I84-10 (IMO) | Always | Below 1 Ω |
| L30-13 (EFIO) - I84-11 (IMI) | Always | Below 1 Ω |
| L30-12 (EFII) - Body ground | Always | 10 kΩ or higher |
| L30-13 (EFIO) - Body ground | Always | 10 kΩ or higher |
| I84-10 (IMO) - Body ground | Always | 10 kΩ or higher |
| I84-11 (IMI) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L30-12 (EFII) - A29-10 (IMO) | Always | Below 1 Ω |
| L30-13 (EFIO) - A29-11 (IMI) | Always | Below 1 Ω |
| L30-12 (EFII) - Body ground | Always | 10 kΩ or higher |
| L30-13 (EFIO) - Body ground | Always | 10 kΩ or higher |
| A29-10 (IMO) - Body ground | Always | 10 kΩ or higher |
| A29-11 (IMI) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L30-12 (EFII) - A29-10 (IMO) | Always | Below 1 Ω |
| L30-13 (EFIO) - A29-11 (IMI) | Always | Below 1 Ω |
| L30-12 (EFII) - Body ground | Always | 10 kΩ or higher |
| L30-13 (EFIO) - Body ground | Always | 10 kΩ or higher |
| A29-10 (IMO) - Body ground | Always | 10 kΩ or higher |
| A29-11 (IMI) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Temporarily replace the ECM with a new one.
for 1GR-FE: Click hereEngine / Hybrid System>1GR-FE (ENGINE CONTROL)>ECM>REMOVAL
for 1VD-FTV: Click hereEngine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Reregister the ECU communication ID.
Refer to Service Bulletin.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Perform "DTC Output Confirmation Operation" procedure.
Check for DTCs.
B2799 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG