1.INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER
Connect the connector to the tire pressure warning ECU and receiver.
Attach the 2 guides to temporarily install the tire pressure warning ECU and receiver.
Install the bolt.
62640P 2.INSTALL QUARTER TRIM PANEL ASSEMBLY LH
64707D 3.INSTALL QUARTER TRIM JACK COVER SUB-ASSEMBLY
62552F 4.INSTALL REAR SEAT SIDE GARNISH LH
67918A 5.INSTALL REAR DOOR SCUFF PLATE LH
6.INSTALL REAR NO. 2 SIDE SEAT ASSEMBLY LH
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
8. REGISTRATION OF TRANSMITTER ID
9.INSPECT TIRE PRESSURE WARNING SYSTEM
10.PERFORM INITIALIZATION