Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › IMMOBILISER SYSTEM › from 2017.09
RM25T0E _58 Vehicle Interior _029925 THEFT DETERRENT / KEYLESS ENTRY _0138323 IMMOBILISER SYSTEM C

THEFT DETERRENT / KEYLESS ENTRY  IMMOBILISER SYSTEM  B279C  Theft Deterrent System Presence Detection  


DESCRIPTION

This code is stored when an ECM that is incompatible with the engine immobiliser system is installed to the vehicle.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B279C Theft Deterrent System Presence Detection An ECM that is incompatible with the engine immobiliser system is installed (1 trip detection logic*). ECM
DTC Output Confirmation Operation:

Check for DTCs.



*: Only output while a malfunction is present.


Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Operation when Malfunction Detected
Engine cannot be started -

Related Data List and Active Test
DTC No. Data List and Active Test
B279C -

CAUTION / NOTICE / HINT

NOTICE:
·

If the ECM is replaced, refer to Service Bulletin.

·

After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".



PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR

Powertrain > Engine and ECT > Clear DTCs
50002 234

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Start the engine.


b.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR

Powertrain > Engine and ECT > Trouble Codes
50001 234
HINT:

Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.


OK:

DTC B279C is not output.



Result:
Proceed to
OK
NG



OK

NG

3.REPLACE CURRENT ECM WITH PROPER ECM
3.REPLACE CURRENT ECM WITH PROPER ECM
a.

Replace the current ECM with the proper ECM.



Result:
Proceed to
NEXT



NEXT

END