A thermistor is built into the Engine Coolant Temperature (ECT) sensor and it changes its resistance value according to the engine coolant temperature.
The structure of the sensor and connection to the ECM is the same as the intake air temperature sensor.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0116 | Engine Coolant Temperature Circuit Range / Performance Problem | When one of the following conditions is met:
·
If the engine coolant temperature was between -40°C (-40°F) and 60°C (140°F) at engine start, and condition (a) and (b) are met: (2 trip detection logic)
(a)
Vehicle is driven at varying speeds (accelerating and decelerating)
(b)
Engine coolant temperature remains within 3°C (5.4°F) of the engine starting temperature
·
If the engine coolant temperature was more than 60°C (140°F) at engine start, and conditions (a) and (b) are met: (6 trip detection logic)
(a)
Vehicle is driven at varying speeds (accelerating and decelerating)
(b)
Engine coolant temperature remains within 1°C (1.8°F) of the engine starting temperature, and this is successively recorded 6 times |
·
Thermostat
·
Engine coolant temperature sensor |
Comes on | DTC stored |
The engine coolant temperature sensor is used to monitor the engine coolant temperature. The engine coolant temperature sensor has a thermistor that varies its resistance depending on the temperature of the engine coolant. When the coolant temperature is low, the resistance of the thermistor increases. When the temperature is high, the resistance drops. The variations in resistance are reflected in the voltage output from the sensor. The ECM monitors the sensor voltage and uses this value to calculate the engine coolant temperature. When the sensor's voltage output varies slightly, the ECM interprets this as a fault in the engine coolant temperature sensor and sets a DTC.
Examples:
Upon starting the engine, the engine coolant temperature was between -40°C (-40°F) and 60°C (140°F). If after driving for a few minutes, the engine coolant temperature still remains within 3°C (5.4°F) of the starting temperature, a DTC will be set (2 trip detection logic).
Upon starting the engine, the engine coolant temperature was over 60°C (140°F). If after driving for a few minutes, the engine coolant temperature still remains within 1°C (1.8°F) of the starting temperature, a DTC will be set (6 trip detection logic).
If DTCs P0115, P0117 and P0118 are output simultaneously, the engine coolant temperature sensor circuit may have an open or short. Perform troubleshooting for these DTCs first.
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Display (DTC Output) | Proceed to |
|---|---|
| P0116 is output | A |
| P0116 and other DTCs are output | B |
A
B
Remove the thermostat.
Click hereEngine / Hybrid System>1VD-FTV (COOLING)>THERMOSTAT>REMOVAL
Check the valve opening temperature of the thermostat.
80 to 84°C (176 to 183°F)
In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.
Reinstall the thermostat.
Click hereEngine / Hybrid System>1VD-FTV (COOLING)>THERMOSTAT>INSTALLATION
| Proceed to |
|---|
| OK |
| NG |
OK
NG